CONRAD M-PA0290 Solar Power Bank Instruction Manual

CONRAD M-PA0290 Solar Power Bank

Warnings and Symbols Used

These instructions for use contain the following symbols and warnings:

DANGER! This symbol with the signal word “DANGER” indicates a hazard with a high level of risk which, if not avoided, will result in serious injury or death.

WARNING! This symbol with the signal word “WARNING” indicates a hazard with a medium level of risk which, if not avoided, will result in serious injury.

CAUTION! This symbol with the signal word “CAUTION indicates a hazard with a low level of risk which, if not avoided, will result in minor or moderate injury.

ATTENTION! This symbol with the signal word ATTENTION” indicates a possible property damage.

WARNING! EXPLOSION HAZARD! A warning with this symbol and word “WARNING! EXPLOSION HAZARD” indicates the potential threat of explosion. Failure to observe this warning may result in serious or fatal injuries and potential property damage. Follow the instructions in this warning to prevent serious injuries, o danger to life or property damage!

NOTE : This symbol with the signal word “NOTE” provides additional useful information.

This symbol means that the operating instructions must be observed when using the product.

Direct Current

Introduction

Congratulations on the Purchase al PA0290!
Please read the manual and safety Instructions before using the product for the first time. Otherwise damage may result.

Intended Use

This product is an IT device which is solely intended to be used to charge mobile devices which are normally charged through a USB port. This product is not intended for commercial use. Manufacturer is not liable for damages, which result from non-intended use.

Trademark Notice

• USB® is a registered trademark of USB Implementers Forum, Inc.
• The Log link ® trademark and trade name is the properly of their respective owners.
• Any other names and products may be trademarks or registered trademarks of their respective owners.

Scope of Delivery

• Power Bank x 1
• USB Charging Cable x 1
• User Manual x 1

Before Use

When removing all packaging materials from the product, please check the contents inside to see if there is any damage. If you notice any damage or missing parts, please contact the dealer who sold this product.
Elaborated to the best of our knowledge and with utmost diligence we reserve the right of error and technical modifications.

Parts Description

• A Power button
• B Splash proof cover
• C USB-A output x2
• D USB-C input
• E Green solar charging LED indicator
• F Blue battery status LED indicators
• G Solar panel
• H Flashlight: 3 modes (Steady light/SOS/Strobe)
• I Belt clip
• J User manual
• K USB-C to USB-A coble
  
  

Technical Data

Safety Notices

Please familiarize yourself with all instructions for use and safety notices before using the product for the first time. When passing this product on to third parties, please be sure to include all documentation.

• Check the product for visible external damage before use. Do not use the product if damaged or dropped.
• This product may be used by children age 8 years and up, as well as by persons with physical, sensory or mental impairments or lacking experience and / or knowledge, provided they ore supervised or instructed in the safe use of the product and understand the associated risks. Do not allow children to ploy with the product. Never allow children to clean or maintain this product unsupervised.
• DANGER! Packaging materials ore not o toy. Keep all packaging materials out of the reach of children. Suffocation hazard!
• Always use the product on flat and smooth surface. The product could be damaged if it falls.
• Do not expose the product to high temperatures. It may otherwise overheat and be damaged beyond repair.
• Do not operate the product near open flames, e.g. candles.
• The product is not designed for use in rooms with high temperatures or humidity (i.e. bathrooms} or those in which o great amount of dust is generated.
• Do not expose the product to extremely high temperatures. This applies in particular if you ore thinking about storing the product in your car. Over a prolonged period of time, the car and the glove compartment could become extremely hot. Remove electric devices from the car.
• Do not use the product immediately after it hos been brought in from a cold room to a worm room. Allow the product to acclimatize before you switch it on.
• WARNING! Never open the product casing. This product hos no internal ports requiring maintenance.
• WARNING! Improper handling of lithium polymer batteries can result in fire, explosions, hazardous substances leaking, or other dangerous situations! Do not throw the product into the fire, as this could lead to the built-in battery exploding.
• Do not independently convert or modify the product.
• Repairs to the product must be performed by authorized specialized companies or customer service. Improper repairs may place the user in considerable danger. They will also void the warranty.
• Immediately switch the product off and remove the charging cable from the product if you smell burning or see smoke. Have the product examined by a qualified technician before using it again.
• If you use a USB power supply, the socket used must always be easily accessible so that the USB power supply can be quickly removed from the socket in the case of emergency. Please also refer to the manufacturer’s instruction manual.
• Observe the usage restrictions and prohibitions of use for battery-operated products in situations which may be hazardous such as at petrol stations, airports, hospitals, etc.
• WARNING! During charging process, please note that the product must not be covered. There is a risk of warming and overheating.
• Due to the high power consumptions, the power bank must not be charged from a PC or notebook.
• ATTENTION! The solar panel is designed for emergency charging, it should not be the primary charging source. Prolonged exposure under the sun will cause damage to the solar panel.
• The required charging time for the power bank depends on the charging source and its output power.
• ATTENTION! Do not connect any device to the power bank for charging while the power bank itself is charging. Remove the charging cable from the power bank when it is fully charged .

Operation and Use

Charging the Power Bank

The built-in rechargeable battery must be fully charged before using the product.

• To charge the power bank through USB cable, use power supplies with an output voltage of 5 V and the output current of at least 2 A.
  Connect the USB cable K with the USB-C input D of the power bank.
  Connect the other end of the USB cable K to a USB power supply (not included in the scope of delivery) (see fig L).
  The power bank will start charging automatically under sunlight through the solar panel G .

• The green solar charging LED will light while charging by sunlight. Turning to solid blue LED when the power bank is fully charged.

• The battery charging status is shown by LED indicator F .

• This is approximate percentage of power bank capacity but not actual measurement.

Checking the Battery Status

You can check the battery status on the LED indicator F anytime.

• Press the Power button A . The LED indicator F shows the current battery status of the power bank for approx. 30 seconds in terms of F LED indicators G to show overall power bank capacity.

• This is approximate percentage of Battery capacity but not actual measurement.

Charging Mobile Devices with the Power Bank

1. Use provided USB cable K or other charging cable purchased from reliable supplier. Connect USB Type A plug to USB output of the power bank.
2. And connect the other end of the USB cable K to the USB device to be charged. The charging process will start automatically.
3. In case if the charging process does not begin immediately, press the Power button A shortly to begin the charging process. The current battery status of the power bank is shown during the charging process by the LED indicator F .
4. To end the charging process, separate the USB charging cable from the USB device and the power bank. The LED indicator F will switch off after approx. 30 seconds.

When charging 2 devices simultaneously, all output ports will be 5 V and 10 W max.

Flashlight

1. Press Power button A for 2 seconds to turn on the flashlight H .
2. Press Power button A   again to turn on strobe light.
3. Press Power button A again after the strobe light to turn on SOS light.
4. Press Power button A for 2 seconds to turn off the flashlight .

Troubleshooting

Problem
Cause
Solution

The power bank is not being charged.

It may be that the power bank is not connected properly.

Check that it is connected.
In order to charge the power bank, a power supply with 5 V and at lees! 2 A has to be used.

A connected device is not being charged.

The battery is drained.

Charge the battery.

The device is not connected.

Check that it is connected. Lightly press the Power button A to begin the charging process.

The current consumption of the connected device might be too low.

Check your connected device manual and see if your connected device current consumption complies with this product.

The power bank does not react when the button is pressed or when a device is connected, even though the battery is charged.

The power consumption of the connected device is too high. Therefore, the internal overcurrent protection device was activated.

Please unplug your device to be charged and find another suitable power bank for charging .

Cleaning and Care

This product has no internal parts requiring maintenance. Moisture entering the product may result in damage.

• Ensure no moisture enters the product during cleaning to prevent damaging the product beyond repair.
• Do not use abrasive, solvent-based or aggressive cleaners. These can damoge the surfoce of the product.
• Only dean the product with o slightly damp doth and mild washing-up liquid.
• Make sure that all plug contacts are free of dirt and foreign objects.

Storage During Non-use

• Store the product in a dry, dust-free location, protected from direct sunlight.
• If the product is not used for a long time, the built-in battery should be fully charged to prolong its operating life.
• Regularly charge the built-in battery if you do not use the product for a long period of time. This is necessary to preserve the battery.

Disposal

• The packaging is made of environmentally friendly materials, which may be disposed of through your local recycling facilities.
• Contact your municipality for information on how to dispose of your worn-out product.

According to the European WEEE directive, electrical and electronic equipment must not be disposed with consumers waste. Its components must be recycled or disposed apart from each other. Otherwise contaminative and hazardous substances con pollute our environment.
You as a consumer ore committed by low to dispose electrical and electronic devices to the producer, the dealer or public collecting points at the end of the devices life time for free. Particulars are regulated in notional right. The symbol on the product, in the user’s manual, or at the packaging alludes to these terms. With this kind of waste separation, application, and waste disposal of used devices you achieve an important shore to environmental protection.

This disposal is free of charge to you.
Protect the environment and dispose properly.
Please contact your local waste management company or the city municipal administration for more information.
The built-in rechargeable battery cannot be removed for disposal.

Note to EU Declaration of Conformity

The CE mark confirmed that this product meets the main requirements of the Directive 2014/30/EU of the European Parliament and the Council of Europe concerning telecommunications and terminals regarding the Safety and health of users and of electro-magnetic interference compliance. The CE has been demonstrated. These statements are deposited by the manufacturer.

Warranty

The product has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of product defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.
The warranty for this product is 2 years from the date of purchase. Should this product show any fault in materials or manufacture within 2 years from the date of purchase, we will repair or replace it – at our choice – free of charge to you.
The warranty period begins on the date of purchase. Please keep the original sales receipt in a safe location. This document is required as your proof of purchase. This warranty becomes void if the product has been damaged, or used or maintained improperly.

The warranty applies to defects in material or manufacture. This warranty does not cover product parts subject to normal wear, thus possibly considered consumables (e.g. batteries) or for damage to fragile parts, e.g. switches, rechargeable batteries or glass parts.

Warranty Claim Procedure

To ensure quick processing of your case, please observe the following instructions:
Please have the till receipt and the item number (e.g. PA0290) available as proof of purchase. You will find the item number on the type plate, an engraving on the front page of the instructions, or as a sticker on the rear or bottom of the appliance.
If functional or other defects occur, please contact the service department listed either by telephone or by e-mail. You can return a defective product to us and ensure that you enclose the proof of purchase (till receipt) and information about what the defect is and when it occurred.

Service

• Hotline
  10:00 a.m. – 06:00 p.m.
  (+49) 2351-66887-19
  (German landline number)

• Email
  support@logilink.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>