MOUNT PRO ZDT10-C01-US4 Single Monitor Stand Instruction Manual
- June 14, 2024
- MOUNT PRO
Table of Contents
INSTALLATION INSTRUCTION (ZDT10-C01-US4)
If you have any questions, please feel free to contact Customer Service via Amazon before returning.
Safety Caution
BEFORE ASSEMBLY
- Layout all components and hardware. Check all parts are included and undamaged.
- Should anybody intends to install or use this monitor stand, please read and understand this manual carefully.
- If you do not understand these instructions or have any doubt about the safety instructions, assembly or use of this product, please contact our customer service.
WARNING
- This product contains small items that could be a choking hazard if swallowed.
- KEEP AWAY FROM CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED.
- Improper installation, such as using the product for monitors over its load capacity or for any purpose not explicitly specified, may cause damage or serious injury. We would not be liable for any damage or injury caused by improper mounting or inappropriate use.
CAUTION AND MAINTENANCE
- Never allow children to climb, stand, hang, or play on any part of monitor or stand.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
Installation Tools
(Not Included)
Supplied Parts and Hardware
Product Dimensions
STEP 1: Support Pillar Installation
Put Base 1 on the table; put Washers (B) and Bolts (A) on the base; keep
clip holes of Support Pillar 3 toward backside then put Plastic Cover (D) and
Support Pillar 3 under the base. Then tighten the bolts (A) with the 4mm allen
key (G).
STEP 2: Apply Foot Pads to the Base
Hold the Support Pillar 3 with one hand and tear off plastic film of Foot Pads
(F), then attach Foot Pads (F) near four conors of the Base 1 bottom.
STEP 3: Attach the Plate Component to Monitor
3-1 Select Monitor Screw Length
When attaching plate to the flat screen, be careful not to over tighten screws
and be sure that screws do not bottom out in the mounting holes. STEP 3:
(Continued)
3-2 Attach the Plate Component STEP 4: Attach Monitor with Plate Component
to Pillar
1.Choose the appropriate position for your monitors, hang the monitors onto
the Support Pillar. STEP 5: Cable Management
Attach Wire Clips (E) into the holes of Support Pillar. Manage cables with the
Wire Clips (E). STEP 6: Adjustments (If necessary)
Tilt Adjustment
- Slightly loosen tilting bolt with the Allen Key(H).
- Hold the monitor with both hands and adjust monitor to your desired tilt angle.
- Retighten tilting bolt to secure the monitor in place.
Note:
When tilted, if the monitor sags or does not stay, and if the above method is
useless, please feel free to contact our customer service.
STEP 6: Adjustments (If necessary)
Leveling Adjustment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>