MOUNT PRO PR7005 Single Monitor Wall Mount Instruction Manual
- June 14, 2024
- MOUNT PRO
Table of Contents
MOUNT PRO PR7005 Single Monitor Wall Mount Instruction Manual
If you have any questions, please feel free to contact Customer Service via Amazon before returning.
⚠ Safety Caution
Please read this instruction carefully before installation. If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, please contact us.
● This product is designed for use in wood stud or solid concrete wall.
– DO NOT install into drywall alone.
● The wall must be capable of supporting five times the weight of the monitor
and mount combined.
● Incorrect installation may result in product damage or body injury.
WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; please contact our customer service team. Never use damaged parts!
Product Dimensions
⚠ WARNING! DO NOT install into drywall alone.
Parts and Hardware
NOTE: Not all parts and hardware included will be used.
Tools (Not Included)
1 Attach VESA Plate to Monitor
Select Correct Monitor Screw Length
Do not tighten the screws excessively or your monitor might be damaged.
(a) Flat Back
(b) Recessed or Curved Back
2 Attach Arm to Wall
Position the Arm (A) at your desired height, level the wall plate and mark the pilot hole locations.
Install Arm (A) using lag bolts (W-A), anchors (W-B). Tighten the lag bolts until they are pulled firmly against the Arm (A).
Locate your studs. Verify and mark the center of the stud by finding the stud edges using awl and stud finder.
Position the Arm (A) at your desired height and line up the holes with your stud center line. Level the Arm (A) and mark the pilot hole locations.
Install Arm (A) using lag bolts (W-A). Tighten the lag bolts until they are pulled firmly against the Arm (A).
3 Hang Monitor
Install the Upper Arm (B) to the Lower Arm (A). Secure the arm by tightening the inside screw using 3mm Allen key (G). Attach Decorative Covers (C) to wall plate.
Slide the monitor onto the head of swivel arm, install the security bolt (F). Make sure the security bolt is installed before you rotate the monitor.
4 Adjustments (If necessary)
Tilt Adjustment
- Loosen the tilting bolt.
- Adjust monitor to your desired tilt angle.
- Retighten the tilting bolt to fix the intended angle.
Tension Adjustment
The gas spring is pre-set for a load-bearing range of 4-6KG. For intended functioning of the mount, you will need to adjust the tension of Arm in accordance with your monitor weight by 6mm Allen Key (H).
Situation 1: If arm falls down
Solution: Turn the inside screw counterclockwise to increase tension.
Situation 2: If arm rises up
Solution: Turn the inside screw clockwise to decrease tension.
5 Cable Management
Run cables through bottom of the arm.
Adjust monitor position and rotation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>