superbrightleds LSFD-SW3C50-H Selectable CCT/Wattage Linear LED Strip Light User Manual
- June 4, 2024
- superbrightleds
Table of Contents
Selectable CCT/Wattage Linear LED Strip Light
LSFD-SW3C50-H
User Manual
Important: Read all instructions prior to installation.
Wiring Diagram
Safety and Notes
- The product should be installed in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into the lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture.
Failure to properly support the fixture may result in damage or injury, for
which the manufacturer does not assume responsibility.
Check the product labels for specific electrical specifications related to
installation.
Improper installation will void the warranty.
CCT Selection
Use the CCT selection switch to adjust the CCT setting. The switch is located
on the driver.
Installation Instructions (surface mount)
-
Measure and drill holes in the mounting surface.
-
Remove the diffuser lens using the releases pictured to the right.
-
Attach mounting plate. With supply power off, connect wiring.
Note: The conduit can be directly attached to the mounting plate. -
Select desired CCT/wattage values using switches on the driver.
-
Securely mount fixture.
-
Reinstall the diffuser lens.
Installation Instructions (optional hanging kit LSFD-HK)
- Measure and drill appropriate holes in the ceiling and install hooks (not included) if needed.
- Attach cables to ceiling hooks or wrap around suitable pipe or beam.
- Attach triangular hangers to cables, then hang light on them.
- With supply power off, connect wiring.
- Adjust CCT using the switch on the side of the fixture.
Rev Date: V1 03/02/2022
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com