AUDIO HX10 EVO High End Subwoofer User Manual

June 13, 2024
audio

AUDIO HX10 EVO High-End Subwoofer

AUDIO-HX10-EVO-High-End-Subwoofer-PRODUCT

Product Information

Product Name: HX10 EVO

Weight: 8 Kilogram

Dimensions:

  • External Diameter (a): 259 mm
  • Installation Diameter (b): 238 mm
  • Magnet Diameter (c): 156 mm
  • Total Installation Depth (d): 162 mm
  • Installation Depth (e): 147 mm

Specifications:

  • Power: 2x 250 Watt
  • SPL (2,83V, 1m): 89 dB
  • Frequency Range: 22-1000 Hz
  • DC Resistance: 2x 2.1 ohm
  • Nominal Impedance: 2 ohm
  • Resonance Frequency: 35 Hz
  • Voice Coil Diameter: 54 mm
  • X-Max Linear Excursion: 10 mm

Product Usage Instructions

To install the HX10 EVO speaker, follow these steps:

  1. Choose the appropriate cabinet type for your application The recommended options are
    • Geschlossen / sealed with a volume of 19 liters
    • Bass Reflex / Vented with a volume of VBR 30 liters
    • Band Pass with two chambers – V1: 20 liters and V2: 10 liters
  2. If using a sealed cabinet, ensure it has an internal diameter (d) of 90 mm and a length (L) of 200 mm.
  3. If using a vented or bass reflex cabinet, ensure it has an internal diameter (d) of 90 mm and a length (L) of 200 mm. The tuning frequency (Fm) should be set to 60 Hz for V1 and 40 Hz for VBR.
  4. Connect the speaker to your audio system, ensuring the polarity is correct.
  5. Adjust the power output of your audio system to a suitable level.
  6. Enjoy the high-quality sound produced by the HX10 EVO speaker.

Please refer to the official website for more information and support.

Thank You Congratulations on purchasing a high-quality

AUDIO SYSTEM product incl. GERMAN SOUND

  • Important: Completely read this operating instruction before installation and use of the device.
  • Attention: Pay attention to pieces of advice and instructions of the car manufacturer. Check the polarity when connecting the speakers.
  • Important: You will need your purchase receipt as proof of purchase for any and all warranty repairs and for insurance purposes. Keep your receipt, owner´s manual and packing materials in a safe location for possible future use.
  • Attention: Use of sound components can impair your ability to hear necessary traffic sounds and may constitute a hazard while driving your automobile. AUDIO SYSTEM GERMANY accepts no liability for hearing loss, bodily injury or property damage as a result of use or misuse of our products.
  • We recommend installing the equipment by an authorized service center or dealer. A professional fitting and connection is the requirement for further warranty and perfect sound.

Mechanical Installation Tip

  • Warning: First disconnect negative pole of your car battery. Check-polarity, changing polarity may cause serious damage to your car electric. Best speaker positions are the original build in positions. Easy installation and original look are the reasons. Please note that the speakers are installed flat and stable. The quality of the installation decides very much the sound, therefore, attention should be paid to insulation and care during installation. Please note that the speakers are protected from heat, sunlight, mechanical influences, moisture and wetness by accessories from AUDIO SYSTEM. Attention: Install all cables as straight as possible without squashing or laying them over sharp edges. Otherwise this can cause short circuit or damages to your whole installation. Attention: Be careful removing original plastic parts of your car. The fitting parts could be damaged and have to be replaced. Important: The right polarity of all speakers is extremely important for the sound of your car audio system. We recommend changing polarity of the tweeter finding out the best possible sound.
  • The best is to listen and/or to measure it.

Dimensions / Specifications

8 Kilogramm Weight
259 mm External Diameter        ( a )
238 mm Installation Diameter ( b )
156 mm Magnet Diameter      ( c )
162 mm Total Installation Depth ( d )
147 mm Installation Depth       (3e )
HPPC-Papier HPPC Cone Speaker Cone
Elastomer Elastomere Surround/Edge
Druckguss Die-Cast Basket
Nomex Nomex Spider
Kapton Kapton Coil Former
Glasfaser Glas Fibre Dust Protection Cap
Music 2x 250 Watt Power
RMS 2x 200 Watt
dB 89 dB SPL
Fb 22-1000 Hz Frequency Range
Re 2x 2.1 W DC Resistance
Zn 2x 2 W Nominal Impedance
Fs 35 HZ Resonance Frequency
D 54 mm Voice Coil Diameter
+/- 10 mm X-Max Linear Excursion
Qms 4.54 Qms Mechanical Q Factor
Qes 0.56 Qes Electrical Q Factor
Qts 0.50 Qts Total Q Factor
Mms 98 Gramm Moving Mass
Vas 35 Liter Equivalent Air Volume
Bl 12 Tm Force Factor
Sd 275 cm² Effective Membrane Surface

Recommend Cabinets

All calculations including woofer and bass reflex tube

Band Pass Fm 60 Hz
V1 20 Liter
V2 10 Liter
d 90 mm
L 200 mm

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

audio User Manuals

Related Manuals