KSIX BXTW08B Wireless Earphones User Manual

KSIX BXTW08B Wireless Earphones

Product Information

• Earphones playtime: 4-5 hours
• Case playtime: 15 hours
• Earphone battery: 30 mAh
• Case battery: 200 mAh
• Frequency range: 20 Hz – 20 kHz
• Protection rating: IPX4 (splashproof)
• Operation range: 10 meters
• Connectivity: Bluetooth 5.3

In the Box

• 1 x Pair of earphones
• 1 x Charging case
• 1 x USB-A to USB-C cable (30 cm)
• 3 x Pairs of earpads
• 1 x Manual

Important note: Before using your earphones, do not forget to remove the protective plastic covers that you will find in the charging area of each earphone. These are used as protection during transport and are not necessary once you receive your product. You will need to remove them in order to charge the earphones with their charging case.

Product Details

• Earphones with touch control, LED indicators, microphone and charging pins
• Charging case with LED indicators
• Case USB-C charging port
• 3 x pairs of included earpads
• Earphones LED indicators

The earphone’s LED indicator informs about the state of the connection, among other aspects:

• Pairing: A white light will flash quickly until the earphones are paired.
• Connected: A white light will flash every 5 seconds.
• Power on: The earphones cannot be turned on manually.
• Power off: A white light will flash 3 times and no light will be shown afterwards.
• Charging: A fixed white light will show while charging.

Product Usage Instructions

Turn on/off the earphones:

• The earphones turn on automatically when taken out of the charging case.
• To turn them off automatically, place the earphones into the charging case. Once they are in the charging case, they will start to charge automatically.
• To turn them off manually, tap the left or right earphone for 6 seconds, you will then hear the word “Power off”.
• Note: The earphones cannot be turned on manually.

How to pair the earphones:

• Take the earphones out of the charging case to activate the pairing mode automatically.
• Activate the Bluetooth on your device, search for “KSIX OBLIVION” on the available Bluetooth devices list and select it.
• Once the connection has been successful, you will hear the word “Connected”.
• Once the earphones have been connected to a device, they will pair with it automatically when taken out of the charging case.

Troubleshooting:

• If the earphones do not turn on automatically, it should be due to low battery. Please charge the earphones and the charging case.
• If only one earphone is working, it should be due to a connection failure. Please reset the earphones as instructed later in this manual.

Usage method:
Use the touch control to make use of all the functions of the device:

• Play/Pause
• Previous/Next song
• Volume -/+
• Answer/Hang up calls
• Reject calls
• Voice assistants

How to reset the earphones:

• To reset the earphones, disconnect them, access your device’s Bluetooth settings, tap “KSIX OBLIVION”, and then on “Unpair”.
• Place them in the charging case, take them out, and repeat the pairing process.

Charging the earphones:
To charge the earphones, simply place both inside the charging case, and they will start to charge automatically. The LED charging case indicators will light up, as well as the earphones LED indicators. Make sure that both earphones are properly introduced in the case. When both earphones are charged up to 100%, the LEDs will turn off.

Technical specifications

• Earphone playtime: 4-5 hours Case playtime: 15 hours
• Earphone battery: 30 mAh
• Case battery: 200 mAh
• Frequency range: 20 Hz – 20 kHz
• Protection rating: IPX4 (splashproof)
• Operation range: 10 meters
• Connectivity: Bluetooth 5.3
• Technology: True Wireless Stereo (TWS)
• Sensitivity: 109±3 dB
• Impedance: 16 Ω
• Earphones charging time: 1,5 hours
• Case charging time: 2 hours
• Case dimensions: 2.9 x 5.4 x 4.8 cm
• Earphones weight: 7 g (both)
• Case weight: 30 g
• Material: Plastic

In the box

• 1 x Pair of earphones
• 1 x Charging case
• 1 x USB-A to USB-C cable (30 cm)
• 3 x Pairs of earpads
• 1 x Manual

Important note: Before using your earphones, do not forget to remove the protective plastic covers that you will find in the charging area of each earphone. These are used as protection during transport and are not necessary once you receive your product. You will need to remove them in order to charge the earphones with their charging case.

Product details

• Earphones with touch control, LED indicators, microphone and charging pins
• Charging case with LED indicators
• Case USB-C charging port
• 3 x pairs of included earpads

Earphones LED indicators

The earphone’s LED indicator informs about the state of the connection, among other aspects:

Pairing| A white light will flash quickly until the earphones are paired.
---|---
Connected| A white light will flash every 5 seconds.
Power on| The earphones cannot be turned on manually.
Power off| A white light will flash 3 times and no light will be shown

afterwards.

Charging| A fixed white light will show while charging.

Turn on/off the earphones

• The earphones turn on automatically when taken out of the charging case. To turn them off automatically, place the earphones into the charging case. Once they are in the charging case, they will start to charge automatically.
• To turn them off manually, tap the left or right earphone for 6 seconds, you will then hear the word “Power off”.

Note : The earphones cannot be turned on manually.

How to pair the earphones

• Take the earphones out of the charging chase to activate the pairing mode automatically.
• Activate the Bluetooth on your device, search for KSIX OBLIVION on the available Bluetooth devices list and select it. Once the connection has been successful, you will hear the word “Connected”. Once the earphones have been connected to a device, they will pair with it automatically when taken out of the charging case.

Troubleshooting

If the earphones do not turn on automatically, it should be due to low battery. Please, charge the earphones and the charging case. If only one earphone is working, it should be due to a connection failure. Please, reset the earphones as instructed later in this manual.

Usage method

Use the touch control to make use of all the functions of the device:

touch control for 2 seconds.

To play the next song, tap the right earphone touch control for 2 seconds.

Volume -/+| To decrease the volume, tap the left earphone touch control once.

To increase the volume, tap the right earphone touch control once.

Answer/Hang up calls| To answer an incoming call, tap the left or the right earphone touch control once.

To hang up, tap the left or the right earphone touch control once.

Reject calls| To reject an incoming call, tap the left or right earphone touch

control for 2 seconds.

Voice assistants| To activate the voice assistants, tap the right earphone touch control 3 times.

How to reset the earphones

To reset the earphones, disconnect them, access your device’s Bluetooth settings, tap KSIX OBLIVION and then on “Unpair”. Place them on the charging case, take them out and repeat the pairing process.

Charging the earphones

• To charge the earphones, simply place both inside the charging case and they will start to charge automatically. The LED charging case indicators will light up, as well as the earphones LED indicators. Make sure that both earphones are properly introduced in the case. When both earphones are charged up to 100%, the LEDs will turn off.
• It takes about 1 and a half hours to charge the earphones up to full.

Charging the charging case

• The charging case incorporates a USB-C port. There are 4 white LEDs that display the 4 stages of its charge. The 1st stage goes from 0 to 25%, the 2nd from 25 to 50%, the 3rd from 50 to 75% and the 4th from 75 to 100%. For example: if the charging case is charging from 50 to 75%, the 2 first LED indicators will show a fixed white light, while the 3rd one will be flashing, meaning that the case will be charging from stage 2 to 3.
• It takes about 2 hours to charge the charging case up to full. With the charging case being fully charged, you will be able to charge your earphones up to full about 3 times.
• Troubleshooting: If the charging case LED indicators do not turn on during its charge, it should be due to a power supply issue. Please, check if the charging cable is correctly connected to the charging case. Check both ends of the cable, as well as the power supply state and the device you are using to charge, whether it is a wall charger, a powerbank or a PC port.

Maintenance recommendations

• Regularly clean the product with a dry cloth. The product must be disconnected or switched on when you clean it.

• Keep the connectors and/or ports free from dust, lint, etc. to prevent improper connections.

• Avoid breaking the device. Do not put objects over it or bend it too strong.

• If the product includes a cable do not bend it too strong and do not pull from it to unplug the product.

• Do not wet the product. Keep it always in a dry place, away from humidity.

• When not using the product, store it in a place free from dust, dirt, lint, liquids, etc.

• If water or other liquids enter the product interior, unplug it immediately from any attached power source or device it is connected to.

• Avoid dropping or hitting the product. It might be damaged.

• Do not use the product for anything other than its intended use.

• Please recycle the product in accordance with local environmental laws and regulations.

Safety information

Please read the following instructions before using the device for the first time:

• When you use device keep it away from heat sources (fire) and from humidity sources (water and other liquids).
• If the product is wet or damaged do not use it.
• Do not use the product with wet hands.
• Do not leave the product in contact with flammable materials.
• Do not expose the product to high temperatures (for example: inside a car during hot weather)
• Do not throw the product into fire.
• Keep the product away from children.
• Disconnect or switch off the product if you are not going to use it for a long period of time.
• Do not use the device if you perceive any visible defects.
• Do not attempt to open or puncture the product. You might damage it.
• Do not use the product with incompatible devices.
• Do not dismount or modify the product. These actions will invalidate the Warranty.

Legal Note
Hereby, Atlantis Internacional S.L. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EC. The features and functions described in this manual are based on tests made by Atlantis Internacional S.L. It is the user’s responsibility to examine and verify the product after its purchase. Atlantis Internacional S.L. is not responsible and will never be liable for any personal loss or injury, economical loss, material loss or any damage due to misuse, abuse or improper installation of the product. For electronic devices with Bluetooth: Atlantis Internacional S.L. is not responsible and will never be liable for any function, communication and connection failure between the product and Bluetooth-enabled devices.

Electronic and electrical device disposal

This symbol indicates that electrical and electronic equipment is to be collected separately.

• This product is designated for separate collection at an appropriate collection point. Do not dispose of it as household waste.
• The final price of this product includes the cost necessary for the correct environmental management of the generated waste.
• If the equipment uses batteries, they must be removed from the equipment and disposed of in an appropriate collection center. If the batteries cannot be removed, do not attempt to do it yourself since it must be done by a qualified professional.
• Separate collection and recycling help conserve natural resources and prevent negative consequences for human health and the environment that might result from incorrect disposal.
• For more information, contact the retailer or the local authorities in charge of waste management.

CE Declaration of Conformity

We hereby declare that the product (s) listed below satisfies the provision for CE-marking according to the following European directive(s):
EN 50663:2017, EN 62479:2010 EN IEC 62368-1:2020+A11:2020 ETSI EN 301 489-1 v 2.2.3 (2019-11), ETSI EN 301 489-17 v 3.2.4 (2020-09) ETSI EN 300 328 v2.2.2 (2019-07) Artículo/Article/Artigo: BXTW08N / BXTW08B EAN: 8427542130699 / 8427542130705
Manufacturer: ATLANTIS INTERNACIONAL, S.L.
Address : Carrer del Crom, 53, 08907 L’Hospitalet de Llobregat, Barcelona (Spain)
Place and date of the declaration 20 de julio 2023 / July, 20th 2023 / 20 de julho de 2023 Nico Broder General Manager

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>