RAB LIGHTING 73456-RAB FERN Deck Instructions
- June 13, 2024
- RAB Lighting
Table of Contents
RAB LIGHTING 73456-RAB FERN Deck
IMPORTANT
- READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
- RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
- WARNING: Make certain power is OFF before installing or maintaining Fixture. No user-serviceable parts inside.
- WARNING: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened rmly.
- WARNING: MAX 12VAC ONLY.
- WARNING: The main low voltage cable is intended for shallow burial – 6 inches (152 mm).
- WARNING: Risk of Electric Shock. Install all luminaires 10 feet (3.05 m) or more from a pool, spa, or fountain.
WALL MOUNTING
To mount the DECK series follow the steps below.
- Secure the Mounting Bracket to the wall, deck post or any fl at the surface by drilling out (2) Drill Locations as shown. Use the appropriate mounting hardware for the mounting surface.
- Be sure the gasket is properly seated.
- Complete electrical connections using RAB-recommended connectors (ordered separately) to the transformer (ordered separately).
- Note – DECK series is supplied with 36 inches of Fixture Leads out of the fixture.
- WARNING: To prevent wiring damage or abrasion, do not expose wiring to the edges of sharp objects.
- Slide Shade on Mounting Bracket. If the Shade does not seem snug, adjust by slightly bending the Tab in or out.
INSTRUCTIONS
RAB Lighting is committed to creating high-quality, affordable, well-designed,
and energy-efficient LED lighting and controls that make it easy for
electricians to install and end users to save energy.
We’d love to hear your comments. Please call the Marketing Department at
888-RAB-1000 or email:
marketing@rablighting.com
WIRING
The DECK series permits operation at 12 VAC only. Wire fixture using UL- approved wire connectors (ordered separately) for SPT-1 cord
ACCESSORIES
- The following accessories are ordered separately.
- FERNFCC Fixture to Cable Connector
- FERC Cable to Cable Connector
- CORD16/12V-10 0 16GA SPT-2W 12V 3.7A 100FT cord
- RTX12-75-TPC 75WPhotocell Transformer with Timer and Swivel
- RTX12-100-TPC 100W Photocell Transformer with Timer and Swivel
CLEANING & MAINTENANCE
CAUTION: Be sure the fixture temperature is cool enough to touch. Do not clean or maintain while the fixture is energized.
- Lens should be washed in a solution of warm water and any mild, nonabrasive household detergent, rinse with clean water, and wipe dry.
- Do not open the xture to clean the LED. Do not touch the LED
TROUBLESHOOTING
Check that the voltage at the xture is correct. Refer to wiring directions
Note: These instructions do not cover all details or variations in
equipment nor do they provide for every possible situation during
installation, operation or maintenance.
- Easy Answers rablighting.com
- Visit our website for product info
- Tech Help Line
- Call our experts: 888 722-1000
- e-mail Answered promptly – sales@rablighting.com
- Free Lighting Layouts
- © 2023 RAB LIGHTING Inc. Answered online or by request
- RAB WARRANTY : RAB’s warranty is subject to all terms and conditions found at rablighting.com/warranty
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>