Apps Tuya App User Guide
- June 3, 2024
- APPs
Table of Contents
Tuya App
User Guide
Tuya App
APP Funtion:Tuya APP
Matching products: padlock drawer lock cabinet lock
Battery: Lithium battery
Working temperature: -10ºC-45ºC
Working humidity:40%RH-90%RH
USB charging: 5V, Micro USB interface
Before you do the following, make sure your phone’s Bluetooth is turned on and your phone and padlock are within a reasonable distance. It is recommended to operate within 5 meters.
Connect the APP
Search for “Tuya” APP in the application market and download it. Open the APP.
1.1 Click the “+” icon in the upper right corner of the app homepage
1.2 Click on the “Security Sensing” category on the left
1.3 Find the door lock (Bluetooth) and click
1.4 Click “Start Bluetooth Network Configuration”, and at the same time insert
the Bluetooth padlock with USB into the charging state, and turn on the
Bluetooth
1.5 On the Bluetooth search interface, the device name appears, click “OK” to
connect.
1.6 Prompt that the Bluetooth connection is successful 1.7 Bluetooth unlock,
click the unlock button on the device interface to unlock
Fingerprint lock charging instructions
2.1 When charging, the red light is on; when it is full, the green light is on
2.2 Low voltage alarm: after unlocking operation, if the battery voltage is
lower than 3.6V. The low voltage alarm time is about 5 seconds, the red light
flashes once every second, and the buzzer sounds.
2.3 Low-voltage protection: When the voltage is lower than 3.2V, it will enter
the low-voltage protection state, no matter if you touch the fingerprint or
the button, there will be no response. Now you need to plug in the USB to
charge to restore the normal working state.
Product initialization
3.1 Open the APP, enter the unlock interface, and click in the upper right
corner. Enter the next interface.
3.2 Click to remove the device at the bottom, the interface will pop up at the
bottom, click on the interface to unbind and clear the data, the
initialization is successful.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>