NSL LVLDL-04-CCT-WH-R-L3-277 4 Inch Round Thin-Line LED Downlight Instructions
- June 4, 2024
- nsl
Table of Contents
LVLDL-04-CCT-WH-R-L3-277 4 Inch Round Thin-Line LED Downlight
Instructions
LVLDL-04-CCT-WH-R-L3-277 4 Inch Round Thin-Line LED Downlight
120V-277V 3 Color Temperature LED Thin Line Down Light
0-10V dimmable on 120V AC (non-dimmable on 277V AC)
FIXTURE INSTALLATION
LED SERIES
LVLDL-04-CCT-WH-R-L3-277
LVLDL-06-CCT-WH-R-L3-277
Important: Read all instructions in order to ensure safety and proper
installation.
PARTS LIST
- Remote driver
- Light panel
- Spring clips
- Connector
MAINTENANCE
Do not modify this fixture. Any modifications may render the product unsafe
and void warranty.
This product is suitable for wet locations.
Limited Warranty
The warranty applies to the product from the original date of purchase for
five (5) years against manufacturing defects. The owner must provide a copy of
the original proof of purchase. The manufacturer’s obligation under this
warranty is limited to repairing or replacing the component. It is not related
in any way to the cost of the connection, the installation of the replacement
parts, or the cost of transport.
**WARNING**
Turn power OFF from the electrical panel before installation or maintenance.
- Turn power OFF from the electrical panel prior to installation.
- Determine the location for installation and cut ceiling holes in accordance with cut-hole dimensions. Refer to the Hole Diameter table for appropriate sizes. (Fig. 1)
- Insert the electrical cable through the knockout of the remote driver, and secure it with a cable connector.
- Strip 1/3″ (8mm) of the insulation off each incoming 120V (277V) power wire. Connect white wire (neutral) to push-in connector on white wire from remote driver. Connect the black incoming 120V (277V) power wire (hot wire) to the push-in connector on the black wire from the remote driver. Connect the ground wire to the push-in connector from that the non-insulated wire is not exposed. (Fig. 2)
- Place all wiring and connections back into the box and close the cover. Connect the driver to the light panel.
- Insert remote driver through the mounting hole. (Fig. 3)
- Push spring-loaded clips on the fixture upwards and insert the fixture base into the mounting hole. Release the clips and the fixture will be pulled flush to the ceiling. (Fig. 4)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>