Nordval PMPC01 Parking Mode Cable Set User Guide
- June 7, 2024
- Nordval
Table of Contents
Parking mode
cable set
PMPC01
Quick start guide
Notification:
The company is not responsible for any damage caused by not following this
manual.
Read the complete manual before installing the cable set.
Make sure the vehicle’s engine is turned off
The location and layout of the fuse panel and the type of fuses used depend on
the vehicle.
Connect the red ACC (+) to the fuse panel
Check your car owner’s manual to find out where the fuse panel is located.
Remove the cover from the fuse panel. Remove a switched
fuse from the fuse panel like, for example, the audio system or cigarette
lighter. Reinstall the red ACC (+) in the fuse panel where the
switched fuse was just removed.
Connect the yellow BATT (+) to the constant power connection
Remove a constant supply fuse from the fuse panel like, for example, the
hazard light, rear light, or interior lighting.
Replace the yellow BATT (+) in the fuse panel where the constant power fuse
was just removed. If the car uses a battery storage
function (Battery Saver Function), make sure that the yellow BATT (+) wire is
connected to the location of the hazard light.
Connect the black GND wire to a grounding point
Attach the GND wire to a grounding point, such as a bolt, located directly on
a metal part of the vehicle frame.
Connect the micro-USB cable to the Nordväl dashcam
Place the dashcam in the correct position on the front window of the vehicle.
Plug the micro-USB cable into the dashcam.
Start the engine and check that the dashcam turns on and continues to record
once the car is turned off.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>