NSL GDL Series 5CCT LED Gimbal Down Light Installation Guide
- June 11, 2024
- nsl
Table of Contents
NATIONAL SPECIALTY LIGHTING
YOUR TRUSTED LIGHTING PARTNER
5CCT LED Gimbal Down Light
GDL-3-8W-38-CCT-WH
GDL-4-14W-38-CCT-WH
GDL-6-18W-38-CCT-WH
FIXTURE INSTALLATION
Important: Read all instructions in order to ensure safety and proper
installation.
MAINTENANCE
Do not modify this fixture. Any modifications may render the product unsafe and void warranty.
Limited Warranty
The warranty applies to the product from the original date of purchase for
five (5) years against manufacturing defects. The owner must provide a copy of
the original proof of purchase. The manufacturer’s obligation under this
warranty is limited to repairing or replacing the component. It is not related
in any way to the cost of the connection, the installation of the replacement
parts or cost of transport.
INSTALLATION GUIDE
WARNING
Disconnect power before installation or maintenance.
Installation:
- Turn power OFF from the electrical panel prior to installation.
- Determine the location for installation and cut ceiling hole in accordance with cut-hole dimensions. Refer to Installation Hole Size for cutting hole diameters. (Fig. 1)
- Insert the electrical cable through the knockout of the remote driver, and secure it with a cable connector.
- Strip 1/3” (8mm) of the insulation off each incoming 120V power wire. Connect white wire (neutral) to the white wire from remote driver. Connect black incoming 120V power wire (hot wire) to the black wire from remote driver. Connect ground wire to the ground wire of the remote driver. (Fig. 2)
- Place all wiring and connections back in to the box and close the cover. Connect the driver to the light panel.
- Insert remote driver through the mounting hole. (Fig. 3)
- Secure the junction box in the ceiling with the screws provided.
- Push spring-loaded clips on the fixture upwards and insert fixture base in to the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. (Fig. 4-5)
NOTE: Use packaging inside box as installation hole cutting template to mount the fixture in the ceiling.