Micron CK106 Rescue Device with Voice Function User Manual
- June 13, 2024
- Micron
Table of Contents
Micron CK106 Rescue Device with Voice Function
Introduction
CK106 is a rescue device with a voice function. It works on LTE B2/B4/B5/B12/B13 networks with superior receiving sensitivity. Based on the embedded wireless tracking protocol, CK106 can communicate with the backend server through the LTE network, and transfer emergency reports.
Product Overview
Appearance
LED Description
Light Event State
- Red LED Power on/Fully charged charging
- Steady light
- Slow flash
Blue LED Power on
- Fix position
- Steady light
- fast flash
To be added
Figure 1-2
There are 2 LED lights in the CK106 device, the description is as follows.
Getting Started
Parts List
Battery Charging
The following items are suggestions for battery charge, please pay more attention. The Battery in the device is a backup battery in power-off mode. The main power is from the automobile battery through the tail patch cord.
Charging will last about 4 hours
Note: If the Rescue device is first used, please make sure the battery is
fully charged, which will make the life of the battery much longer.
Power on/Power off
Power on
If the Rescue device is first used, install the automobile battery to the tail
patch cord.
Power off
The rescue device is auto powered off and the user can’t turn off the machine
by itself.
Frequency
- LTE:Band2、Band4、Band5、Band12、Band13
- WIFI:2.4GHz
- GPS：1575.42MHz、1176.45 MHz
Troubleshooting
Safety info
The following items are suggestions for safety use, please pay more attention.
Please do not disassemble the device by yourself. Please do not put the device
in an overheating or too humid place, avoid exposure
to direct sunlight. Too high a temperature will damage the device or even
cause a battery explosion. Please do not use the device on the airplane or
near medical equipment.
FCC Caution
Labeling requirements
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Information to the user
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. §
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
WIFI Exposure Information
The WIFI of this equipment only has a reception function.
RF Exposure Information (SAR)
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
ISED RSS Warning
This device complies with the Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: ( 1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause
undesired operation of the device.
WIFI Exposure Information
The WIFI of this equipment only has a reception function.
Radiation Exposure Statement (SAR)
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body. This device
complies with the Innovation, Science, and Economic Development Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions: ( 1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired
operation of the device.
WIFI Exposure Information
The WIFI of this equipment only has a reception function.
Radiation Exposure Statement (SAR)
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>