Micron Electronics AIRE Mate202 Waterproof Help Button User Manual
- June 6, 2024
- Micron Electronics
Table of Contents
Micron Electronics AIRE Mate202 Waterproof Help Button User Manual
1. Introduction
AIRE Mate202 is a 433 Pendant which is designed as accessory for Emergency call equipment. It works on 433 protocol .It will send 433 signal After the SOS button being press . The LS100 device which receiver the 433 signal will dial a emergency call.
2. Product Overview
2.1 Appearance
Figure 1-1
2.2 Buttons Interface Description
2.3 LED Description
Figure 1-2
There are 1 LED lights in AIRE Mate202 device, the description as following.
3 Getting Started
3.1 Parts List
3.2 Built-in Battery
The following items are suggestion for built-in battery usage, please pay more
attention.
- The device is a pendant ,which is designed to be used with LS100 Base station .
- There is a button battery(CR2430) integrated in device. The Pendant will automatically power on when the button battery is assembled .
3.3 LS100 Base station
The LS100 base station is a LTE/CAT1 emergency call device which could be used
to response to the 433 data sending from the PD002 Pendant by custom protocol
. The adapter is used for device power on, built-in battery charging , which
should be plugged in power supply socket at any time ( by end user).
Figure 2-1
3.4 Power on/Power off
Figure 2-2
Power on:
- The Pendant will automaticly power on when the button battery is assembled .
Power off:
- UnPlugged the button battery.
Note: the user can change the button battery when the battery is dead.
4. Frequency
433:433.92MHz
5. Trouble shooting and Safety info
5.1 Trouble shooting
5.2 Safety info
The following items are suggestion for safety use, please pay more attention.
- Please do not disassemble the device by yourself.
- Please do not put the device on the overheating or too humid place, avoid exposure to direct sunlight. Too high temperature will damage the device or even cause the battery explosion.
- Please do not use Prime PD002 on the airplane or near medical equipment.
FCC Caution.
Labelling requirements.
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Information to user.
Any Changes or modifications not expressly approved by the party responsible
for
compliance could void the user’s authority to operate the equipment.
Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6
W/kg averaged over one gram of tissue. This device was tested for typical
body-worn operations with the back of the handset kept 0cm from the body. To
maintain compliance with FCC RF exposure requirements, use accessories that
maintain a 0.5cm separation distance between the user’s body and the back of
the handset. The use of belt clips, holsters and similar accessories should
not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF exposure
requirements, and should be
avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 0cm must be maintained
between the user’s body and the handset, including the antenna. Third-party
belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
IC Warning
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1)This device may not cause interference;
(2)This device must accept any interference, including interference that may
cause undesired operation of the device.
The information listed above provides the user with information needed to make him or her aware of a RF exposure, and what to do to assure that this radi o operates within the FCC exposure limits of this radio.
The device complies with RF specifications when the device used at 0mm from the body.Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>