kogan KATVFSW65LM Solid Wood TV Floor Stand User Guide

June 13, 2024
Kogan

kogan KATVFSW65LM Solid Wood TV Floor Stand

SAFETY & WARNINGS

Read the entire user guide before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, contact your local distributor for assistance.

CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

  • Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
  • Safety gear and proper tools must be used. This product should only be installed by professionals.
  • This product includes an anti-tip kit that must be used in conjunction with the product and will prevent the unit from falling or tipping over. Follow the enclosed information to properly install these safety accessories.
  • This product is designed to be installed on solid concrete walls, masonry walls or wood stud walls.
  • Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
  • Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
  • This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
  • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
  • Never exceed the maximum load capacity of 50kg or it may result in product failure or personal injury.

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of purchase for a replacement.

MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at least every three months).

kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-1

COMPONENTS

kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-2

ASSEMBLY

Step 1:

kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-3

Step 2:
Loosen the screw and insert part A into part C.kogan-KATVFSW65LM-Solid-Wood-
TV-Floor-Stand-FIG-4

Step 3:

  • Attach the two assemblies together and secure them in place using an M6x70 Screw (I).
  • Cover the screw with the plastic cover (G). Note: To remove the plastic cover, press the right side in until the cover pops out.kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-5

Step 4:
Ensure the fastener is vertical and insert a M6x90 Screw (J) into the assembly .kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-6

Step 5:

  • Attach the locking collar (H) to the assembly and secure it into position using the M6x30 Screw (L).
  • Place the D45.5 Washer (K) onto the stand.

Note: Ensure the screw is properly threaded into the hole. The locking collar must be in position before attaching a TV to the stand.kogan-
KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-7

Step 6:

kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-8

Step 7:

  • Attach the brackets (E & F) to the rear of the TV and secure them in place using the supplied screws (“M-” set) and washers (M-E).
  • The cable clips (P-B) will need to be attached to the upper bracket (E).

Note: Depending on your TV you may need to install the spacers (M-F & M-G ).kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-9

Step 8:

  • Carefully attach the TV to the stand. Enlist the help of a second person to safely carry the TV.
  • Close the clasp on the lower bracket (F) and tighten the screw (F1).

Note: Ensure there is at least 20mm clearance between the bottom of the TV and the stand.kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-
FIG-10

Step 9:

  • To avoid the TV falling, it is highly recommended to install anti-fall hardware.
  • Mark the desired position for the anti-fall bracket (P-C).
  • Drywall/plaster: Drill a pilot hole using a 3.5mm drill bit and drill.
  • Masonry/concrete: Drill a pilot hole using a 7mmmm drill bit and drill.kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-11

Step 10:

  • Drywall / plaster: Secure the anti-fall bracket (P-C) to the wall using the ST4.8×38 Screw (P-E).
  • Masonry / concrete: Secure the anti-fall bracket (P-C) to the wall using the wall anchor (P-F) and ST4.8×38 Screw (P-E).

kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-FIG-12

Step 11:
Using the anti-fall rope (P-A), cable clips (P-B) and rope screws (P-D) secure the TV to the Wall.

Note: Ensure there is enough tension on the rope so that the TV will not tip over.kogan-KATVFSW65LM-Solid-Wood-TV-Floor-Stand-
FIG-13

Need more information?
We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals