SIIG 4K60Hz HDMI over Cat6 Extender with Loopout and IR – 50m User Guide

SIIG 4K60Hz HDMI over Cat6 Extender with Loopout and IR – 50m

Features

• Extend HDMI signal over CAT6 Ethernet cable 4K up to 164ft / 50m 1080p up to 230ft / 70m
• Supports resolution up to 4K@60Hz 4:4:4
• SupportsHDR10
• Supports HDCP 2.2 & 1.4
• Transmitter supports HDMI loop-out
• HDMI Audio Format LPCM 2 / 5.1 / 7.1, DTS 5.1, Dolby 5.117.1
• Supports IR pass back (frequency 20-60KHz)

Package contents

• Transmitter
• Receiver
• Power adapter DC 5V/0. 5A x2
• IR blaster extension cable
• IR receiver extension cable
• Quick Start Guide

Layout

TX

1. Power jack : DC 5V/0.5A
2. RJ-45 : Connect to receiver via CAT6 cable
3. IR output : Connect with blaster extension cable
4. Reset hole : Press the pinhole to restart device
5. Power LED : Solid blue when power on
6. HDMI output : Connect to display
7. HDMI input : Connect to video source

RX

1. Power jack : DC 5V/0.5A
2. RJ-45 : Connect to transmitter via CAT6 cable
3. IR input : Connect to receiver extension cable
4. Reset hole : Press the pinhole to restart device
5. Power LED : Solid blue when power on
6. HDMI output : Connect to display

Application

IRcable

IR blaster

1. Power
2. IR Signal
3. Null

IR receiver

1. Power
2. IR Signal
3. Grounding

EDID Auto Balance

• The extender will auto-learning connected display’s EDID from RX, for resolution & audio output channel
• If TX loop-out also connected display, the extender will use the smaller display EDID of two displays

For example:

1. Two displays are 4K@60Hz 2 audio channels & 1080p@60Hz 5.1 audio channels, the extender will use 1080p@60Hz 2 audio channels EDID for Two displays Output resolution will be 1080p@60Hz Audio output will be 2 channels
2. Two displays are 4K@60Hz 7.1 audio channels, the extender will use 4K@60Hz 7.1audio channels EDID for Two displays Output resolution will be 4K@60Hz Audio output will be 7.1 channels

FAQ

• Q: The devices are connected correctly, but why is there no image displayed?
  • Please make sure the HDMI cable meets the transmission requirement
  • Please check and make sure the network cable is connected well
  • Restart the transmitter or receiver by pressing the reset hole
• Q: Why does the display occasionally have a black screen?
  • Check if the length of the cable is within the specified range
  • Reset the transmitter or receiver to rebuild the connection
• Q: Why is the display color abnormal or no sound?
  • Reset the transmitter or receiver to rebuild the connection
  • Check if the HDMI cables are connected well
  • Reconnect the network cable

Support

For more info or tech support http://www.siig.com/support Copyright © 2022 by SIIG, Inc. All rights reserved.

References

• SIIG Support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>