DS18 BRO-SBAR-BK Rear Overhead Soundbar System for 6th Gen Ford Bronco 4 Door Owner’s Manual
- June 10, 2024
- DS18
Table of Contents
DS18 BRO-SBAR-BK Rear Overhead Sound bar System for 6th Gen Ford Bronco 4
Door Owner’s Manual
REAR OVERHEAD SOUNDBAR SYSTEM FOR 6TH GEN FORD BRONCO 4-DOOR MODEL
FEATURES
- Especially designed for the 4-door model.
- Rear Facing Fits 4 x any 8” DS18 Speakers (NXL-8 Recommended) *
- Forward Facing Fits 2 x any 6.5” DS18 Speakers (NXL-6 Recommended) *
- Forward Facing Fits 2 x any DS18 2.9” Mounting Hole Tweeter (PRO-TW1L Recommended) *
- Fits Speakers up to 3.93” / 100mm Mounting Depth
- high density plastic molded with black color injected
- UV protected and all elements ready
- lightweight and strong abs material
- mounting hardware included
- 3.2ft / 1m Wiring included for Speakers and RGB LED lighting**
- Pre-wired for 4-Channels Amplifiers***
- (sold separately)
- RGB LED Controller (optional) not included
- Aftermarket Amplifier required not included
INSTALLATION
Start by removing the rear factory speakers by removing the top two screws and
one on the bottom side, we recommend removing the roof of the Bronco for
better access. then use those same points to screw the BR-SBAR bar, first
secure the bar and then install the speakers. run the wire down one side of
the bronco down then connect to your installed amp to power the new speakers
and you’re done.
OVERALL VIEW
AMPLIFIER SIDE INSTALLATION
- RGB led lights from the soundbar: connect this to the LED-BTC (Sold separately)
- This goes to the roof for the sound bar.
- Soundbar speaker harness: connect this to the “Roof” amplifier (Wh: CH1+, Wh/Bk: CH1-, Gy: CH2+, Gy/Bk: CH2-, Gr: CH3+, Gr/Bk: CH3-, Vt: CH4+, Vt/Bk: CH4-).
To connect without LED Control Module (LED-BTC), Connect as Shown in the Following Diagram:
- Black wire”BK” connected to battery Positive (+) 12V
- White Color Light “R”; “B” and “G” connected to battery Negative (-)
- Green Color Light “G” connected to battery Negative (-)
- Red Color Light “R” connected to battery Negative (-)
- Blue Color Light “B” connected to battery Negative (-)
- Purple Color Light “R” and “B” connected to battery Negative (-)
- Yellow Color Light” R” and “G” connected to battery Negative (-)
- Cyan Color Light “B” and “G” connected to battery Negative (-)
MEASUREMENTS
DOWNLOAD THE DS18 LED BTC APP
COMPATIBLE WITH DS18 LED-BTC OR ANY OTHER RF/BT/WIFI CONTROLLER FOR MULTI-
FUNCTION RGB LED LIGHTING. (SOLD SEPARATELY)
WARRANTY
Please visit our website DS18.com for more information on our warranty policy.
We reserve the right to change products and specifications at any time without
notice. Images may or may not include optional equipment.
WARNING:
Cancer and Reproductive Harm.
www.P65Warning.ca.gov
Symbols
