Luminii RAIN Recessed Downlight Installation Guide

Table of Contents

Product Information:

Product Usage Instructions:

Before installing or maintaining the RAIN product, it is important to read and follow the provided instructions.
Drivers and Wiring:
- The on-site installer needs to provide wire for the connection between the driver and the fixture.
- Non-Dimming Driver: Use model number 902-35010 (10W) Constant Current. Wire 1-7 fixtures per driver in series. The remote driver can be mounted horizontally or vertically, with a minimum clearance of 2 inches (51mm) required for proper air circulation.
- Dimming Driver: Use model number 902-35025 (25W) Constant Current. Wire 3-17 fixtures per driver in series. The remote driver can also be mounted horizontally or vertically, with a minimum clearance of 2 inches (51mm) required for proper air circulation.
- Class II Wiring is applicable. 3.
Installation Steps:
- Cut a hole to the correct size and in the desired locations.
- Finish the surface and ensure that the wiring reaches all locations. Pull the wire through the hole and make electrical connections.
- Compress the 2 springs towards the fixture until it clears the hole. Push the fixture into the ceiling until it is securely in place.
- Additional details regarding installation can be found in the provided user manual.
  Note : The information provided is based on the text extract from the user manual and may not cover all aspects of product usage. It is recommended to refer to the complete user manual for comprehensive instructions and safety guidelines.

Read and follow these instructions before installing or maintaining this product

This product is suitable for WET LOCATIONS
Make sure this product is NOT on the same circuit as inductive loads, (e.g. fluorescent bulbs, discharge bulbs, ventilation fans, etc…)
Allow air to flow freely around the fixture
Do not switch on line voltage until all wiring is complete
Incorrect wiring will result in irreparable damage to LED and power supply
This product should only be installed by a licensed electrician

Warranty

This product must be installed in accordance with all applicable installation codes and ordinance
Limited five (5) years warranty
warranty is void in the eventuality of unauthorized modifications and/or improper use

On-site installer to provide wire for connection between driver and fixture.

Non-Dimming Driver: 902-35010 (10W)
Constant Current

1-7 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for proper air circulation.

Dimming Driver: 902-35025 (25W)
Constant Current

3-17 Fixtures per driver wired in series.
Remote Driver can be mounted Horizontally or Vertically.
Minimum clearance of 2” (51mm) around the driver is required for proper air circulation.

Luminii-RAIN-Recessed-Downlight-fig.2

Cut hole to correct size and in all desired locations.
Finish surface and ensure wiring reaches all locations. Pull wire through hole and make electrical connections.
Compress the 2 spring towards to fixture until it clears the hole. Push fixture into ceiling until.