luminii LLDW52 LineLED 24V LED Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LLDW52 LineLED 24V LED Strip Light Instruction Manual
info@luminii.com
www.luminii.com
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
Attention : Always test Line LED operation before installing.
Connect Line LED to power supply to ensure it is working properly and no
damage has occured during shipping.
- Clean the area thoroughly where the Line LED will be installed.
Remove the paper backing from the Line LED and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
- If length of Line LED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no wire leads.
- Always ensure power to power supply is off! Follow diagrams on page 2 to connect power feed wires to power supply.
Wiring Diagrams
Using DMX LED power supply
Using non dimming LED power supply, receiver and controller
Using warm dim LED power supply
Using tunable white LED power supply
Using non dimming LED power supply, decoder and controller
Using non dimming LED power supply and decoder
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
REV0.7 24082022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>