luminii LLDW36 LineLED 24V LED Strip Light Installation Guide
- June 4, 2024
- luminii
Table of Contents
luminii LLDW36 Line LED 24V LED Strip Light
Please read all instructions prior to installation and keep for
future reference!
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit.
- Suitable for Damp Locations.
- For under-cabinet or shelf mount.
- Conforms to UL STD 2108. Certified to CSA STD C22.2 No.250.0.
Attention: Always test Line LED operation before installing. Connect Line LED to power supply to ensure it is working properly and no damage has occurred during shipping.
Installation Instructions
-
Clean the area thoroughly where the Line LED will be installed.
Remove the paper backing from the Line LED and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
NOTE – When removing backing & laying Line LED to surface avoid installing
with ripples & bending over 90°. NOTE – Avoid bending near 1” on both side
of the soldered joints. -
If length of Line LED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no wire leads.
-
Always ensure power to power supply is off! Follow diagrams on page 2 to connect power feed wires to power supply.
Wiring Diagrams
Using DMX LED power supply
Using non dimming LED power supply, receiver and controller
Operations to Controller
- Press the learning key on the receiver, then push the rotary button. Once successfully learn, the LED lights will blink an the receiver. Do the same far the ether receivers if you use them, you can add as many optional receivers as you want.
- Short press once the rotary button to switch on/off. Adjust dim brightness by the rotary button from left to right 0. 1 – 100%. Adjust dim brightness by the rotary button from right to left 0.1 – 100%. Long press rotary button, the light will be 100% brightness
Double click rotary button, it will enter into dimming color temperature mode, dim WW & CW associatively, far example if WW is 70%, CW is 30%. Double click again, will enter into dimming brightness mode.
Using warm dim LED power supply
Using tunable white LED power supply
Using non dimming LED power supply, decoder and controller
Using non dimming LED power supply and decoder
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>