luminii LL54-XX LineLED 24V LED Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LL54-XX LineLED 24V LED Strip Light Instruction Manual
Installation Instructions
Please read complete instruction prior to installation and keep for future reference!
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
- Conforms to UL STD 2108. Certified to CSA STD C22.2 No.250.0.
Attention:
Always test LineLED operation before installing. Connect LineLED to power supply to ensure it is working properly and no damage has occured during shipping.
Clean the area thoroughly where the LineLED will be installed.
Remove the paper backing from the LineLED and firmly press down making surethere are no air bubbles that can cause surface irregularities. Do not remove theadhesive, removing the adhesive may cause arcing of the Line LED tape.
NOTE – When removing backing & laying LineLED to surface avoid installing with ripples & bending over 90°.
NOTE – Avoid bending near 1” on both side of the soldered joints.
If length of LineLED needs to be adjusted on site, simply cut the LED strip in
between solder pads. Always cut from end with no connector/wire leads.
Installation Instructions
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite ends.
Always ensure power to power supply is off! Follow diagrams to connect power
feed wires to power supply. Refer to power supply instructions for wiring line
voltage side.
CUSTOMER SUPPORT
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>