luminii LLS36 LineLED 24V LED Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LLS36 LineLED 24V LED Strip Light
Please read complete instructions prior to installation and keep them for
future reference!
Attention:
Always test LineLED operation before installing. Connect LineLED to a power
supply to ensure it is working properly and no damage has occurred during
shipping.
Installation Instruction
- Clean the area thoroughly where the LineLED will be installed.
- Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
If length of LineLED needs to be adjusted on site, simply cut the LED strip in
between solder pads. Always cut from end with no connector/wire leads
.
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE
POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite
ends.
Always ensure the power to the power supply is off! Follow diagrams to connect
power feed wires to power supply. Refer to power supply instructions for
wiring line voltage side. 
LUMINII RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE.
7777 N. Merrimac Ave Niles, IL 60714 T 224.333.6033 F 224.757.7557 info@luminii.com. www.luminii.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>