luminii LLHE48-XX LineLED 24V LED Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LLHE48-XX LineLED 24V LED Strip Light
Please read all instructions prior to installation and keep them for future reference!
- LLHE48-HO MUST BE PAIRED WITH AN APPROVED LUMINII EXTRUSION
- THE PRODUCT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
- ENSURE POWER IS OFF AT FUSE BOX PRIOR TO INSTALLTION TO PREVENT ELECTRICAL SHOCK
- USE ONLY WITH CLASS 2 POWER UNIT
- SUITABLE FOR DAMP LOCATIONS
- FOR UNDER-CABINET OR SHELF MOUNT
- CONFORMS TO UL STD 2108. CERTIFIED TO CSA STD C22.2 NO.250.0.
ATTENTION: ALWAYS TEST LINED OPERATION BEFORE INSTALLATION. CONNECT LINELED TO POWER SUPPLY TO ENSURE IT IS WORKING PROPERLY AND NO DAMAGE HAS OCCURED DURING SHIPPING.
INSTALLATION STEPS
- Clean the area thoroughly where the LineLED will be installed.
- Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive! Removing the adhesive may cause arcing of the Line LED tape!
- If the length of LineLED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from end with no connector / wire leads
- RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINE LED FED WITH SEPARATE POWER SUPPLIES
- Position power supplies either in the middle of both runs or at opposite ends.
- Always ensure the power to power supply is off. Follow diagrams to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side
LUMINII RESERVES THE RIGHT TO CHANGE SPECIFICATIONS & INSTRUCTIONS WITHOUT NOTICE
7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>