luminii LLWD68 LineLED 24V LED Strip Light Instruction Manual

June 4, 2024
luminii

luminii LLWD68 LineLED 24V LED Strip Light

luminii-LLWD68-LineLED-24V-LED-Strip-Light-
PRODUCT

Installation Instructions

Please read complete instructions prior to installation and keep them for future reference!

  1. The product should be installed by a qualified electrician.
  2. Prior to installation ensure power is off at the fuse box to prevent electrical shock.
  3. Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
  4. Suitable for Damp Locations. Convient Aux Emplacements Humides.
  5. For under-cabinet or shelf mount.

Attention

  • Always test LineLED operation before installing.
  • Connect LineLED to a power supply to ensure it is working properly and no damage has occurred during shipping.

luminii-LLWD68-LineLED-24V-LED-Strip-Light-FIG-1

  1. Clean the area thoroughly where the LineLED will be installed.
  2. Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities.
  3. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.luminii-LLWD68-LineLED-24V-LED-Strip-Light-FIG-2
  4. If the length of LineLED needs to be adjusted on site, simply cut the LED strip in between solder pads. Always cut from the end with no wire leads.

RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINE LED FED WITH SEPARATE POWER SUPPLIES

  1. Position power supplies either in the middle of two runs or at the opposite ends.
  2. luminii-LLWD68-LineLED-24V-LED-Strip-Light-FIG-3Always ensure power to the power supply is off! Follow diagrams to connect power feed wires to the power supply. Refer to power supply instructions for wiring line voltage side.
  • Connect positive wire (plus sign tag or red wire) to RED low voltage wire from the power supply. Also, connect negative wire (no tag or black wire) to PURPLE low voltage wire from the power supply.

luminii-LLWD68-LineLED-24V-LED-Strip-Light-FIG-5

  • Connect positive middle wire (plus sign tag) to RED low voltage wire from the power supply. Also, connect BOTH negative wires (no tags) to PURPLE low voltage wire from the power supply.

LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals