luminii LLFLEX18 LineLED Flex 24V LED Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LLFLEX18 LineLED Flex 24V LED Strip Light
Please read all instructions prior to installation and keep them for future reference!
- The product should be installed by a qualified electrician.
- Prior to installation ensure power is off at the fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
Attention:
Always test LineLED Flex operation before installing. Connect LineLED to a
power supply to ensure it is working properly and no damage has occurred
during shipping.
Installation Instruction
Remove the paper backing from the LineLED Flex and firmly press down making
sure there are no air bubbles that can cause surface irregularities to the
LineLED. LineLED Flex can bend up to 90° along the bend points. Do not remove
the adhesive, removing the adhesive may cause arcing of the Line LED tape
.
NOTE
Avoid bending the LineLED Flex in sharp horizontal angles. When laying LineLED
to the surface avoid ripples on LineLED.
If length of LineLED flex needs to be adjusted on site, simply cut between the
solder pads. Always cut from end with the wire leads. 
RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE
POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite
ends.
Always ensure the power to the power supply is off!
Follow diagrams to connect power feed wires to the power supply. Refer to
power supply instructions for wiring line voltage side.
LUMINII RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave Niles, IL 60714 T 224.333.6033 F 224.757.7557 info@luminii.com. www.luminii.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>