luminii LL36 LineLED Wet 24V Strip Light Instruction Manual

June 4, 2024
luminii

luminii LL36 LineLED Wet 24V Strip Light

Please read all instructions prior to installation and keep for future reference!

  1. The product should be installed by a qualified electrician.
  2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
  3. Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
  4. Suitable for Wet Locations. Convient Aux Emplacements Mouilles.
  5. For under-cabinet or shelf mount.
  6. Avoid exposure to direct sunlight.
  7. Not suitable for applications where LEDs can become submerged

INSTALLATION STEPS

  1. Attention: Always test LineLED strip before installing. Connect LineLED to power supply to ensure it is working properly and no damage has occured during shipping.
    Clean the area thoroughly where the LineLED will be installed. Use the included Heat Sink Tape for all installation of LineLED unless its on a Luminii profile or non-painted aluminum to ensure proper heat dissipation. LineLED may not reach it’s rated average life when installed otherwise.luminii LL36 LineLED Wet 24V Strip Light FIG
\(1\)

  2. Remove the paper backing from the LineLED and firmly press down making sure there are no air bubbles that can cause surface irregularities to the LineLED. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tapeluminii LL36 LineLED Wet 24V Strip Light FIG \(2\)

  3. Install clip, part number CL -1, every 6.00” to secure LineLED Wet to mounting surfaceluminii LL36 LineLED Wet 24V Strip Light FIG \(3\)

  4. If installing LineLED Wet inside an extrusion that is facing up, drainage holes should be drilled along the inner corner of the extrusion at every 12”. Drill 1/16” to 1/8” diameter holes before installing LineLED Wet. Also, silicone should be applied to edges of the endcaps and lens before installing onto extrusion.luminii LL36 LineLED Wet 24V Strip Light FIG \(4\)

  5. Always ensure the power to the power supply is off! Follow the diagram below to connect power feed wires to the power supply. Refer to power supply instructions for wiring line voltage sideluminii LL36 LineLED Wet 24V Strip Light FIG \(5\)

LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE

7777 Merrimac Ave Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals