luminii LL18WET LineLED Wet 24V Strip Light Instruction Manual
- June 4, 2024
- luminii
Table of Contents
luminii LL18WET LineLED Wet 24V Strip Light Instruction Manual
Please read all instructions prior to installation and keep for future reference!
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Wet Locations. Convient Aux Emplacements Mouilles.
- For under-cabinet or shelf mount.
- Avoid exposure to direct sunlight.
- Not suitable for applications where LEDs can become submerged.
Attention: Always test LineLED strip before installing.
Connect LineLED to power supply to ensure it is working properly and no damage
has occured during shipping.
NOTE – Avoid gaps when laying heat sink tape to the surface. If necessary overlap the heat sink tape ends.
Clean the area thoroughly where the LineLED will be installed. Use the included Heat Sink Tape for all installation of LineLED unless its on a Luminii profile or non-painted aluminum to ensure proper heat dissipation. LineLED may not reach it’s rated average life when installed otherwise.
Remove the paper backing from the LineLED and firmly press down making sure
there are no air bubbles that can cause surface irregularities to the LineLED.
Do not remove the adhesive, removing the adhesive may cause arcing of the
Line LED tape.
NOTE – Avoid bending the LineLED in sharp horizontal angles which may damage
the LEDs
NOTE – Avoid bending near 1” on both side of the soldered joint
NOTE – When removing backing & laying LineLED to surface avoid ripples on
LineLED.
Install clip, part number CL -1, every 6.00” to secure LineLED Wet to mounting
surface.
If installing LineLED Wet inside an extrusion that is facing up, drainage
holes should be drilled along the inner corner of the extrusion at every 12”.
Drill 1/16” to 1/8” diameter holes before installing LineLED Wet. Also,
silicone should be applied to edges of the endcaps and lens before installing
onto extrusion.
Always ensure power to power supply is off! Follow diagram below to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side.
Connect positive red wire to RED low voltage wire from power supply.
Also, connect negative black wire to PURPLE low voltage wire from power
supply.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
info@luminii.com
www.luminii.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>