COOLON 06 Luminaire LED Lighting ARIA X RGBW Instruction Manual
- June 13, 2024
- COOLON
Table of Contents
- PROFILE DIMENSIONS
- INSTALLATION LIMITS @ 230VAC
- INSTALLATION LIMITS @ 120VAC
- WIRING CONFIGURATION
- CONNECTION
- ROTATION WITH MOUNTING BRACKETS
- DIMENSIONS WITH GLARE SHIELD
- ROTATION WITH MOUNTING BRACKETS + GLARE SHIELD
- ADJUSTING THE MOUNTING BRACKET
- SAFETY LANYARD
- Customer service
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
COOLON 06 Luminaire LED Lighting ARIA X RGBW
PROFILE DIMENSIONS
INCLUDED
Box Contents
- 600mm Fitting
- Mounting Brackets (Integral)
+ Run Box
- Allen Key
- Cable Plastic Caps
- Cable Kits
| CONTENTS | LxWxH DIMENSIONS | WEIGHT |
|---|---|---|
| 1 x 06 Luminaire | 582 x 191 x 121mm | 4.2kg |
| 2 x 06 Luminaire | 582 x 191 x 121mm | 8.4kg |
ATTENTION
- Please observe / follow the instructions methodically.
- Please ensure the units are handled with extreme care.
- Do not remove product from packaging prematurely. Only remove from packaging when ready for installation.
- Failure to observe installation instructions and handling will void warranty of the product.
- Fittings must be installed by a licensed electrician.
- Before installing, make sure the power supply is switched off or mains cable is disconnected.
INSTALLATION LIMITS @ 230VAC
Maximum 24 x 600mm fittings per individual run.
INSTALLATION LIMITS @ 120VAC
Maximum 12 x 600mm fittings per individual run.
WIRING CONFIGURATION
- CBLKIT-MADA-J-0.6M
- CBLKIT-MADA-J-5M
- CBLKIT-MADA-J-CST
- Integral to 06 lengths only
DATA Loom Wiring
MAINS Loom Wiring
CONNECTION
Before installation begins, please ensure that you understand the fitting layout as per luminaire schedule
DIMENSIONS
Bracket Bottom View
ROTATION WITH MOUNTING BRACKETS
DIMENSIONS WITH GLARE SHIELD
Bracket Bottom View
ROTATION WITH MOUNTING BRACKETS + GLARE SHIELD
ADJUSTING THE MOUNTING BRACKET
STEP 1
Loosen Screws A and B counter clockwise to allow for rotation of the
luminaire.
STEP 2
Rotate the luminaire to your desired angle.
STEP 3
Tighten Screws A and B clockwise to lock into position (4 – 5Nm).
SAFETY LANYARD
Please utilize provisioned apertures if safety lanyards are required in the installation.
Customer service
archsales@coolon.com.au aus. 1300 287 533
intl. +613 8681 3633 www.coolon.com.au
All documentation is subject to change without notice. Refer to our website
for the latest information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>