COOLON Ex Tunnel Ray Industrial Led User Manual
- June 12, 2024
- COOLON
Table of Contents
COOLON Ex Tunnel Ray Industrial Led
Product Information
- Product Name: Ex TUNNEL RAY INDUSTRIAL LED
- Manual Edition: 0.5
Dimensions:
- Length: 398mm
- Width: 352mm
- Height: 242mm
Dimension
CONDITION OF USE T he equipment may be operated in an ambient temperature range of -20°C to 50°C.
WARNING
Do not open any covers or optics. Factory sealed – no user serviceable parts
inside. Potential electrostatic charging hazard – see cleaning instructions
below.
CLEANING INSTRUCTIONS
In order to ensure safe light levels are maintained during operation the optical face of the luminaire should be cleaned at regular intervals. The optical covers are made from polycarbonate.
- Use lukewarm soapy water and a soft sponge or cloth to clean the optical surface. If luminaires are not accessible by hand use a long-poled car or RV washing pad.
- If using soapy water rinse using clean water.
- After final rinse dry off with a soft cloth. Polycarbonate is vulnerable to scratching.
- Do not scrub with brushes, abrasive materials or sharp instruments as these will mark the surface.
- Never use solvents, alkaline cleaners, thinners or abrasive cleaners.
- Do not steam clean or high pressure wash.
- Never use: acetone, petrol, benzene, or solvents containing Butyl Cello solve or Isopropanol.
- Incorrect cleaning which in any way damages the unit automatically renders void all warranties.
INSTALLATION INSTRUCTIONS
Step 1
Choose luminaire position and orientation. When choosing the location of
Tunnel Ray luminaire, please ensure that sufficient clearance is allowed for
the airflow through heatsink. Avoid blocking the air vents.
EXTERNAL EARTHING
When mounted on a non-conductive or non-earthed facilities, the body of the luminaire needs to be externally grounded. One of the 4x M6 nesters can be used as appropriate. It is recommended that a spring/locking washer and 4mm2 cable with a suitable terminal is used (not supplied with the fitting).
WIRING
Mains (100 – 240VAC) Version
Cable needs to be terminated in a suitable enclosure such that the outer
sheath provides the sealing for the inner sheath and conductors.
This is to eliminate the possibility of any ingress due to the capillary
effect created as the unit goes through the warm up and cool down
cycles.
support@coolon.com.au • aus. 1300 287 533 •
intl. +613 8681 3633 • www.coolon.com.au
As a matter of continual improvement, the requirements and recommendations in
our manuals evolve to reflect new industry requirements and the latest
feedback from the field.
The Coolon team is working hard to ensure optimal product operation and the
safety of all users, please check our website periodically to ensure you are
up to date with the latest information.
Product must be installed by a suitably qualified person. All documentation is
subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>