ACCURATE M9134ELR Mortise Lock Instructions
- June 13, 2024
- Accurate
Table of Contents
ACCURATE M9134ELR Mortise Lock
M9134ELR MOTOR DRIVE ELECTRIFIED LATCH RETRACTION
Rotating inside handle or using electronics simultaneously retract latch and deadbolt (when extended).*
Latch bolt by key outside or using electronics, egress by handle inside. Deadbolt manually projected by thumb turn inside or key outside. Outside trim (if applicable) is always rigid. FAIL SECURE OPERATION ONLY: Latch retracts when power is applied.
*For applications requiring the deadbolt not to retract the latch via electronics, please add DM Monitor and program access accordingly.
KEY FUNCTION
The main latch bolt may be momentarily retracted with a key.
ELECTRICAL SPECIFICATIONS
Filtered and Regulated Power Supply.
VOLTAGE: 24VDC (21VDC – 30VDC)
CURRENT: 625 mA MAX Inrush, 150 mA MAX Holding Non-polarized leads.
2 Conductor Wire Run
Distance| Wire Gauge
125’| 22
200’| 20
350’| 18
500’| 16
800’| 14
1250’| 12
ONBOARD INDICATOR LIGHT ASSIGNMENTS
Maintain input power to the mortise lock and check the onboard indicator lights. Remove input power before attempting a solution.
GREEN
(POWER)
| YELLOW
(SENSOR)| RED
(ERROR)| INDICATION|
POSSIBLE SOLUTION
---|---|---|---|---
Off
| Off| Off| No Power.|
Connect the wiring between the power supply and the mortise lock.
On
| On| Off| Normal Operation. The main latch bolt is retracted to the preset
retracted position. The device is allowed 2 attempts.|
On| Off| On| Error in operation. The main latch bolt did not retract to the
preset retracted position within 2 attempts|
Clear the jam condition manually.
On
| On| On| Error in operation. Without power being removed, the main latch bolt unintentionally extended from the preset retracted position, and then the main latch bolt did not retract back to the preset retracted position within 2 attempts.|
Clear the jam condition manually.
On
| Blink| On| Error in operation. The main latch bolt did not extend from the
preset retracted position when the power was last removed. The device will not
attempt a retraction.| Clear the jam condition manually.
On| Simultaneous Blink| Error in operation. The input voltage dropped below
the specification during operation.|
Decrease the wire run or increase the wire gauge.
On
| Alternating Blink| Error in operation. An electronics fault was detected.|
An electronics replacement is required.
CUSTOMERS SUPPORT
1 Annie Place Stamford, CT 06902 I 203.348.8865
www.accuratelockandhardware.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>