NINGBO RSL875TB RSL Wireless Remote Control Door Lock Instruction Manual
- June 13, 2024
- Ningbo
Table of Contents
NINGBO RSL875TB RSL Wireless Remote Control Door Lock
Operating elements
ON
OFF
2H-Plug OFF after 2hous
4H-Plug OFF after 4hous
6H-Plug OFF after 6hous
8H-Plug OFF after 8hous
Inserting/replacing battery
- Remove the battery compartment lid from the back of the remote control.
- Insert one round cell battery, type CR2032, into the battery recess. The positive pole should face upward (see the “+” imprint on the battery). Push the battery all the way into the battery recess.
- Close the battery compartment. The battery must be replaced when the remote control’s range decreases noticeably or when the indicator lamp no longer lights when a button is pushed.
Key functions
- The control keys of first row are arranged in two columns: left column = ON/ right column = OFF.
- Use the 2H/4H/6H/8H keys to activate the corresponding timing set individually . The indicator lamp lights up each time a key is pressed.
The remote control can control an unlimited number of compatible plugs.
Technical data
Battery type …………………………CR2032
Number of channels ……………..2 channel
Transmission frequency…………433.92 MHz
Transmission range ………………max. 150ft (in open area)
Dimensions (W x H x D) ………..33 x 65x 12 mm
Weight ………………………………..16 g
Notice
Do not ingest battery, Chemical Burn Hazard
This product contains a coin / button cell battery. If the coin / button cell
battery is swallowed, it can cause severe internal burns in just 2 hours and
can lead to death.
Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product and keep it away from
children. If you think batteries might have been swallowed or placed inside
any part of the body, seek immediate medical attention.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This device generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the device and receiver.
–Connect the device into an outlet on a circuit different from that to which
the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>