profi-pumpe 5 WATERPUMP Pump Control Inverter Instruction Manual
- June 13, 2024
- profi-Pumpe
Table of Contents
PUMP CONTROL/INVERTER
VERSION 22.06
TROUBLESHOOTING INSTRUCTIONS
5 WATERPUMP Pump Control Inverter
FLUOMAC®
Pump Automatic-Controller|
---|---
FLUOMAC® 6-2 & 6-2-1
Pump Automatic-Controller|
Pump Automatic-Controller|
Pump Automatic-Controller|
TEEPRES®-1
Pump Automatic-Controller|
PRESFLO-2-VARIO®
Pump Automatic-Controller| 
BRIO®
Pump Automatic-Controller| 
WATERPUMP-INVERTER
2,2KW 5,0KW 5,5KW 7,5KW| 
WATERPUMP-INVERTER
0,75KW 1,1KW| 
WATERPUMP-INVERTER
2,2KW 1,5KW| 
WATERPUMP-INVERTER
01,1KW 0,75KW| 
PRESFLO2-2
Pump Automatic-Controller|
DOUBLE PUMP CONTROLLER 1| 
STEADYPRES®
Pump Automatic-Controller
16,0Amp/ 12,0Amp/ 11,0Amp/ 8,5Amp/8,0Amp/ 7,0Amp/ 6,0Amp| 
PRESFLO-2-MULTI®
Pump Automatic-Controller| 
Technical changes, misprints and mistakes reserved! Newest information about
our products can be found online: http://www.profi-pumpe.de
**Problem:
** The pump is switched „on“ by the pump control (inverter, etc.) at certain
intervals for no apparent reason and then switched „off“ after a short time
(pump cycling).
Check all tapping points (water tap, WC-tank etc.) for leaks.
If a pump control with internal or external check valve is used, dirt in the
check valve is the most frequent cause of the fault.
1 Remedy
Turn all water taps on maximum flow to clean/flush the check valve integrated
in the pump control.
2 Remedy
Install an additional non-return check valve before pump control of the flow
(never use a second check valve without cycling the pump).
If the fault cannot be eliminated by the measures described, the pump control
must be replaced.
Imprint
Amur S.à r.l.
www.amur.lu
Email: info@amur.lu
Tel.: (+49) 0611-9 45 87 77-0
Fax: (+49) 0611-9 45 87 77-11
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>