insinkerator 5XP 9 Step AquaSaver And Disposer Installation Guide

insinkerator 5XP 9 Step AquaSaver And Disposer

FOODSERVICE DISPOSER CONTROL CENTER LIMITED WARRANTY

InSinkErator Foodservice Disposer Control Centers are warranted against defects in material and workmanship for Three Year for AS101 from the date of installation. The warranty includes parts and labor, provided the service is performed by an InSinkErator Factory Authorized Service Center. This warranty does not apply if failure is due to: faulty or improper electrical installation, faulty or improper plumbing installation, product abuse or misuse, or accidental damage. Foodservice disposer accessories are included in this warranty only if they are included in the original disposer purchase package.

STOP

Please read the Troubleshooting Guide and/or visit

• www.insinkerator.com
• before calling 1-800-845-8345

TROUBLESHOOTING

What You Should Know Before

Beginning

This is a quick reference guide. Please refer to the complete Installation, Care & Use Manual for specifics including warnings, cautions and dangers. If after reading the troubleshooting section, you still have questions about parts, installation or warranty, please visit www.insinkerator.com/foodservice or call 1-800-845-8345. Please have the model and serial number of your AS101 Control Panel and Disposer when calling. Visit www.insinkerator.com/foodservice for assistance on many common questions.

Installation

Quick & Easy Steps to AquaSaver® Installation

See Installation, Care & Use Manual for important cautions, warnings and dangers

1. Verify that all components are the same voltage and phase as your main power supply

2. Install disposer per Installation Manual

3. A. Install solenoid valves using cold water supply

   • B. Complete plumbing to sink or trough per local codes

4. Connect drain to disposer per local codes
   WARNING
   ELECTRICAL SHOCK
   Turn off the electrical supply to the disposer before attempting any work on it. Use a voltmeter or circuit tester to ensure that power is off. Installation must conform to local electrical codes. All control centers and disposers must be carefully and permanently grounded. A properly fused disconnect must be installed at the electrical supply source for the control center.

5. Install AS-101 Control Center per Installation Manual

6. Make solenoid connections inside AS-101 Control Center per Installation Manual
   NOTICE
   PROPERTY DAMAGE
   Ensure that the control centre voltage and phase match the disposer motor and electrical supply. Check nameplates on disposers and control centers for voltage and phase specification. The disposer motor wiring connection is shown in the disposer terminal box.

7. Connect the disposer and AS-101 Control Center together per Installation Manual

8. Connect main Power Supply to AS-101 Control Center per Installation Manual and local codes

9. See the Installation Manual to set current sensor

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>