COOLON Lonsdale RGBW LED Lighting Instruction Manual
- June 13, 2024
- COOLON
Table of Contents
COOLON Lonsdale RGBW LED Lighting Instruction Manual
DIMENSIONS
Top cap is typically white. Base is typically grey Can be painted to specification of the light pole.
Maximum installation height = Standard 4 – 6 metres, or up to 20 metres with longer cable.
-
PLE-LONSDALE-RGBW-05
8.75kg
-
PLE-LONSDALE-RGBW-10
10.5kg -
PLE-LONSDALE-RGBW-15
12.25kg
-
PLE-LONSDALE-RGBW-20
14.0kg
DRIVERS & PSUS
RDM CV NEO • DRV-RDM CV NEO-RJ45F-OJ5-IP65
RJ45F · CAT5 Ethernet Female Connector
- 1 DMX +
- 2 DMX –
- 7 Common
- 8 Common
OJ5 · Outdoor Joiner 5 Pin’
CH3
CH4
Common
CH1
CH2
60W POWER SUPPLY
60W POWER SUPPLY 150W POWER SUPPLY
STEP 1
Fit Lonsdale RGBW pole over spigot and ensure cable is fed through carefully
to avoid any damage.
Recommended Spigot Size
NPS 2½ / DN 65
Outer Ø: 73mm
Min. Length: 190mm
A riser of NPS 3½ / DN 90 will match the luminaire’s outer diameter.
Installer should grip the assembly from the base.
STEP 2
Secure using 2x M6 and 1x M10 set-screws with a torque of 8 – 9Nm. All 3
screws must be tightened.
STEP 3
Wire up according to the wiring diagram
WIRING
- NOTE 1
Maximum overall distance from power supply to luminaire MUST NOT EXCEED 20 metres if AWG13 or 1.83mm2cable is used.
Luminaire cable (5 Core) is typically supplied at 4 metres, for longer cables please advise Coolon at procurement stages
-
NOTE 2
Cool DMX or any other standard DMX / RDM controller can be used. -
NOTE 3
Typical CAT5 / CAT6 outdoor circular cable supplied by others. Maximum 300m from DMX control unit to the last RDM / DMX driver in a typical daisy chain topology. -
NOTE 4
Installer to ensure fitment of RDM and PSU considering physical dimensions and appropriate location relative to luminaire.
archsales@coolon.com.au aus. 1300 287 533
intl. +613 8681 3633 www.coolon.com.au
All documentation is subject to change without notice. Refer to our website
for the latest information