Lights Lotus LED-1-S7W-5CCT LED Ceiling Light Instruction Manual

June 13, 2024
Lights Lotus

LED-1-S7W-5CCT LED Ceiling Light
Instruction ManualLights Lotus LED-1-S7W-5CCT LED Ceiling
Light Installation Instructions
Model LED-1-S7W-5CCT

LED-1-S7W-5CCT LED Ceiling Light

IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING FIXTURES. KEEP FOR FUTURE REFERENCE.
SAFETY: FOR YOUR SAFETY, THIS FIXTURE MUST BE WIRED IN ACCORDANCE TO LOCAL ELECTRICAL CODES AND ORDINANCES. ALL WORK SHOULD BE DONE BY A QUALIFIED ELECTRICIAN.
WARNING: MAKE SURE POWER IS OFF FROM THE ELECTRICAL PANEL BEFORE STARTING INSTALLATION OR ATTEMPTING ANY MAINTENANCE. INDOOR INSTALLATION ONLY.
TOOLS REQUIRED: SAW, MEASURING TAPE, ELECTRICAL WIRING (USE TAPE AND GAUGE SUITABLE FOR APPLICATION TO CONNECT THE FIXTURES.

PRE-INSTALLATION:

  1. Mount the appropriate trim (Round or Square) on the module.
  2. Twist the trim to lock on the module securely
  3. Turn power OFF from the electrical panel before starting installation
  4. Locate a suitable position to place the fixture and open in accordance to the cutout dimensions (Refer to cutout template) for appropriate size.
  5. Run electrical wire from the switch (power supply) through the mounting hole. Use NMD90 Romex or BX cable.

DRIVER WIRING:

  1. Open the hardwire box swing cover and remove the appropriate knockout(s).
  2. Insert the electrical supply cable through the knockout and secure with a cable connector (sold sepparately).
  3. Using the enclosed quick connectors, connect green ground wire of supply cable to green wire of driver, black wire of supply cable to black wire of driver and white wire of supply cable to white wire of driver.(Fig. 2)
  4. Place all wiring and connections back into the box and close the cover.
  5. Insert hardwire box through the mounting hole. (Fig. 3)

NEW CONSTRUCTION APPLICATIONS:
Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
REMODEL APPLICATIONS:
Do not require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.

FIXTURE INSTALLATION:

  1. Connect the fixture to the hardwire box by inserting and twisting the male/female connectors. (Fig. 5)
  2. Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. (Fig. 6)
  3. Once assembly is complete, turn on power to confirm fixture is working properly.

Lights Lotus LED-1-S7W-5CCT LED Ceiling Light - figureLights Lotus LED-1-S7W-5CCT LED Ceiling Light - figure
1Lights Lotus LED-1-S7W-5CCT LED Ceiling
Light - figure 2Lights Lotus LED-1-S7W-
5CCT LED Ceiling Light - figure 3

Hole Cut Size / Taille Trou Decoupe
02-1/8″(54mm) for round and square trims

844 245 6887
 support@lotusledlights.com
****www.LotusLEDLights.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Lights Lotus User Manuals

Related Manuals