SLIK BT-2 Bluetooth Remote User Manual
- June 1, 2024
- SLIK
Table of Contents
BT-2 Bluetooth Remote
Specifications SLIK
Remote control model：BT-2
Chip model：YC1089X
Size: L 38.5 x W 28 x H 11mm Weight: 6.5g (Within battery)
Features: Support IOS11.4.1 and Android 5.1.1 or above
Power supply: Built-in 3.0V/1632 button cell
Bluetooth 4.2 BLE
Bluetooth protocol: HCI
Working voltage: 3.0V(button cell )
Working current: keystroke current is 2.5mA, first stage sleep
is 0.5mA(no operation), second stage sleep is 2uA
Effective distance: remote control distance up to 10 meters
ISM frequency band: 2402MHz– 2480 MHz
Operation SLIK
On
1.Put the button to “ON”
2.The Bluetooth remote will start the automatic
pairing state after the machine is turned on
Off
Put the button to “OFF”
Connection of Bluetooth remote SLIK
Search name: BT-2
When the indicator light is flashing, means the
Bluetooth remote is being paired. Then you can
search BT-2 on your phone. The indicator light
is not flashing once the Bluetooth remote has
connected your phone
Shooting
After the Bluetooth remote connected with the
phone, to change your phone to “shooting”
model, then press the shutter of remote is ok to
take the photo.
Attention:
The Bluetooth of your phone must be open during working.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>