Lotus LED Lights LED-1-S7W-5CCT Square Budget Super Ceiling Light Instruction Manual

June 13, 2024
Lotus LED Lights

Installation Instructions
Square Budget Super Thin LED 4” and 6” models
LED-S9W-5CCTWH-SQ and LED-S12W-5CCTWH-SQ

LED-1-S7W-5CCT Square Budget Super Ceiling Light

Lotus LED Lights LED 1 S7W 5CCT Square Budget Super Ceiling Light - Figure
1| Lotus LED Lights LED 1
S7W 5CCT Square Budget Super Ceiling Light - Figure 2
---|---
Lotus LED Lights LED 1 S7W 5CCT Square Budget Super Ceiling Light - Figure
3| Lotus LED Lights LED 1
S7W 5CCT Square Budget Super Ceiling Light - Figure 4

IMPORTANT : Read all instructions before installing fixtures.
Retain for future reference.
SAFETY : For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
WARNING : Make certain power is OFF from the electrical panel before starting installation or attempting any maintenance.
Indoor installation only.
TOOLS REQUIRED:

  • Saw
  • Measuring Tape
  • Electrical Wiring (use type and gauge suitable for application to connect the fixtures

PRE-INSTALLATION:

  1. Turn power OFF from the electrical panel before starting installation.
  2. Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
  3. Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.

DRIVER WIRING:

  1. Open the hardwire box swing cover and remove the appropriate knockout (s).
  2. Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately).
  3. Using wire nuts, connect green ground wire of cable to green wire on box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box. (Fig. 1)
  4. Place all wiring and connections back in to the box and close the cover.
  5. Insert hardwire box through the mounting hole. (Fig.2) New construction applications: Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
    Remodel applications: Do not require the hardwire box to be frmly secured after the mounting plates, studs. joists. or structural units have been concealed.

FIXTURE INSTALLATION:

  1. Connect the fixture to the hardwire box by inserting and twisting the male/female connectors. (Fig.3)
  2. Push spring loaded clips on the fixture upwards and insert fixture base in to the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. (Fig.4)
  3. Once assembly is complete. turn on power to confirm fixture is working properly.

Compatible Dimmers

BRAND FAMILY MODEL
LUTRON SKYLARK CONTOUR CTCL-153P

DVCL-153PDH
CT-600P
DIVA| DVCL-153F
LEVITON| DECORA| 6672
6674
PASS & SEYMOUR| HARMONY| HCL453PTCCCV6

Hole Cut Size

4″ Round Ø4-1/4″(Ø108)
6″ Round Ø6-1/4″(Ø158)

844-245-6887
support@lotusledlights.com
www.LotusLEDLights.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals