Lotus LED Lights S9W-5CCTWH-R-BF Round Regressed Baffle LED Instruction Manual
- June 13, 2024
- Lotus LED Lights
Table of Contents
Lotus LED Lights S9W-5CCTWH-R-BF Round Regressed Baffle LED
IMPORTANT : Read all instructions before installing fixtures. Retain for
future reference.
SAFETY : For your safety, this fixture must be wired in accordance lo
local electrical codes and ordinances. All work should be done by a qualified
electrician.
WARNING : Make certain power is OFF from the electrical panel before
starting installation or attempting any maintenance. Indoor installation only.
TOOLS REQUIRED:
- Saw
- Measuring Tape
- Electrical Wiring (use type and gauge suitable for application to connect the fixtures
PRE-INSTALLATION:
- Turn power OFF from the electrical panel before starling installation.
- Locate a suitable position to plate the fixture and open in a=dance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
- Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
DRIVER WIRING:
- Open the hardwire box swing cover and remove the appropriate knockout (s) .
- Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately) .
- Using wire nuts, connect green ground wire of cable to green wire on box. Connect while wire of cable to while wire of box. Connect black wire of cable to black wire of box. (Fig.1)
- Place all wiring and connections back in to the box and close the cover.
- Insert the hardwire box through the mounting hole. (Fig.2) New construction applications: Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
Remodel Application: Do not require the hardwire box to be firmly secured after the mounting plates, studs., joists, or structural units have been concealed.
FIXTURE INSTALLATION:
- Connect the fixture to the hardwire box by inserting and twisting the male/ female connectors. (Fig.3)
- Push spring loaded clips on the fixture upwards and insert fixture base in to the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. (Fig.4)
- Once assembly is complete. turn on power to confirm fucture is working properly.
Compatible Dimmers
Phone: 844-245- 6887
Support : lotusledlights.com
www.LotusLEDLights.com
Documents / Resources
|
Lotus LED Lights S9W-5CCTWH-R-BF Round Regressed Baffle
LED
[pdf] Instruction Manual
LED-S9W-5CCTWH-R-BF, LED-S12W-5CCTWH-R-BF, S9W-5CCTWH-R-BF Round Regressed
Baffle LED, Round Regressed Baffle LED, Regressed Baffle LED, Baffle LED, LED
---|---