Lotus LED Lights LED-2-S15W-L5CCTWH-T Trimless LED Downlight Instruction Manual
- June 13, 2024
- Lotus LED Lights
Table of Contents
Lotus LED Lights LED-2-S15W-L5CCTWH-T Trimless LED Downlight
SAFETY PRECAUTIONS
IMPORTANT: Read all instructions before installing fixtures. Retain for future reference.
SAFETY : For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
WARNING: Make certain power is OFF from the electrical panel before starting installation or attempting any maintenance. Indoor installation only.
TOOLS REQUIRED
- Saw
- Measuring Tape
- Electrical Wiring (use type and gauge suitable for application to connect the fixtures
PRE-INSTALLATION
-
Turn power OFF from the electrical panel before starting installation.
-
Locate a suitable position to plate the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size) .
-
Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
-
Align the inside edge of the Zero Clearance plaster frame to the drywall hole and screw in place. (Fig.1)
-
Plaster over the plaster frame, be careful not to fill past raised rim. (Fig.2)
DRIVER WIRING
-
Open the hardwire box swing cover and remove the appropriate knockout (s) .
-
Insert the electrical supply cable through the knockout and secure with a cable connector (sold separately).
-
Using wire nuts, connect green ground wire of cable to green wire on box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box. (Fig.3)
-
Place all wiring and connections back in to the box and close the cover.
-
Insert hardwire box through the mounting hole. (Fig.4)
FIXTURE INSTALLATION
- Connect the fixture to the hardwire box by inserting and twisting the male/ female connectors. ( Fjg.3)
- Insert the fixture to plaster frame, secure the lamp by twisting the fixture appropriately to the plaster frame. (Fig.4)
- Once assembly is complete, turn on power to confirm fixture is working properly.
Compatible Dimmers
BRAND | FAMILY | MODEL |
---|---|---|
LUTRON | SKYLARK CONTOUR | CTCL-153P |
DVCL-153PDH
CT-600P
DIVA| DVCL-153P
LEVITON| DECORA| 6672
6674
PASS & **SEYMOUR**| HARMONY| HCL453PTCCCV6
Hole Cut Size
2″ Trimless Downlight 02-5/8″ (67mm)