Micron PT201B GPS Locator or Tracker User Manual

Tracker
PT201B User Manual
Revision: 1.00 

PT201B GPS Locator or Tracker

Introduction

PT201B is a powerful GPS locator which is designed for vehicle, human, pets and assets tracking. It works on LTE B2/B4/B12/B14/B66 with superior receiving sensitivity. Its location can be real time or schedule tracked by backend server or specified terminals. Based on the embedded wireless tracking protocol, PT201B can communicate with the backend server through LTE network, and transfer reports of emergency, Geo‐fencing, device status and scheduled GPS position etc… Service provider is easy to setup their tracking platform based on the functional wireless tracking protocol.
The WIFI function will be activated and report the MAC addresses once the device is in alerting state. GPS will be activated and report location information and the back‐end server will be notified with location data once the device is in alerting state. The BLE function will be activated and scan the third‐party BLE data or Beacon broadcast by custom setting or protocol.

Product Overview

2.1 Appearance

2.2 Buttons

Button /12PIN Interface Description

KEY/interface| Description
Power Key| Power on   PT201B
Power off   PT201B (If power key is enabled)
Function Key| SOS mode
Reset Key| Click the key will turn off internal VBAT when OS is abnormal, and then press Power Key to restart   PT201B.
TEST Key| Long press to make a call

2.3 LED Description

There are three LED lights in PT201B device, the description as following.

LTE LED
Power LED
GPS LED| Power on| Flash every 2 seconds
Power off| Dark
Power key was pressed and prepare to Solid power on|
Power on and normal| Dark
Fully charged| Solid
In charging| Slow flash
Power key was pressed and prepare to Solid power off|
Power key was pressed and prepare to Solid power on|
GPS positioning successful| Solid
GPS failed| Dark
Power key was pressed and prepare to Solid power on|
Power off| Dark

Getting Started

3.1 Parts List

3.2 Battery Charging
The following items are suggestion for battery charge, please pay more attention.

• During the charging process, the Power LED light will slow flash. When the battery is fully charged, the Power LED light will be Ever‐dark.
• You can charge the battery using charging dock which connects PT201B device with the Adapter.
• Charging will last about 5 hours.

Note: If the PT201B device is firstly used, please make sure the battery is fully charged, which will make the life of battery much longer.
3.3 PT201B Charger
PT201B is Charging with an AC Adapter.
The charger is used for device charging , which can be used for charging at the any time ( by end user)..

3.4 Power on/Power off

Power on:

• Press the Power key at least 3 seconds and release it to power on PT201B device. Note that, the Power LED light will light for a moment and then turn off.

Power off:

• Press the power key about 3 seconds; Power LED light will light for a moment and then turn off, which indicates that PT201B device has been powered off.

Note: the user can not power off PT201B if the power key is disabled by protocol.

Frequency

LTE: B2/B4/B12/B14/B66
GPS:1575.42MHz
Ble:2402‐2480Mhz (Receiving only)
WIFI: 2412‐2462MHz (Receiving only)

Trouble shooting and Safety info

5.1 Trouble shooting

for the right APN.
The IP address or port of the backend server is wrong.| Make sure the IP address for the backend server is an identified address in the internet.
Unable to power off PT201B.| The function of power key was disabled by
AT+GTFKS.| Enable the function of power key by AT+GTFKS.
Battery can not be charged| The battery has not been used for too long time and has been locked.| Using a external power source with 3.6V to 4.2V DC power supply to active the battery or apply for after sale help.
PT201B can’t fix The GPS successfully.| GPS signal is weak.| Please move PT201B to a place with open sky.
It is better to let the top surface face to the sky. (The same surface with indication LED)

5.2 Safety info
The following items are suggestion for safety use, please pay more attention.

• Please do not disassemble the device by yourself.
• Please do not put the device on the overheating or too humid place, avoid exposure to direct sunlight. Too high temperature will damage the device or even cause the battery explosion.
• Please do not use PT201B on the airplane or near medical equipment.

§ 15.19 Labelling requirements.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR) :
The SAR limit of USA (FCC)is 1.6W/Kg averaged over one gram of tissue for body and 4 W/kg averaged over ten gram of tissue for limb . Product Type: Tracker ,(FCC ID: ZKQ-AHALO) has also been tested against this SAR limit. The device was test for typical body-worn operations and head face up operations keep the Tracker at least 5mm from the face.when worn on body must be correct back clip for this product, Use of non-approved accessories may result in exposure levels which exceed the uncontrolled envirnomental RF exposure limits. The highest reported SAR level for usage near the body (5mm) is 1.396 W/kg, The highest reported SAR level for Limb (0mm) is 1.277 W/kg.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
The SAR limit of ISED is 1.6W/Kg averaged over one gram of tissue for body and 4 W/kg averaged over ten gram of tissue for limb . Product Type: Tracker ,(IC: 8414B-AHALO) has also been tested against this SAR limit. The device was test for typical body-worn operations and head face up operations keep the Tracker at least 5mm from the face.when worn on body must be correct back clip for this product, Use of non-approved accessories may result in exposure levels which exceed the uncontrolled envirnomental RF exposure limits. The highest reported SAR level for usage near the body (5mm) is 1.396 W/kg, The highest reported SAR level for Limb (0mm) is 1.277 W/kg.

Revision: 1.00

Documents / Resources

| Micron PT201B GPS Locator or Tracker [pdf] User Manual
ZKQ-AHALO, ZKQAHALO, PT201B, PT201B GPS Locator or Tracker, GPS Locator or Tracker, Locator or Tracker, Tracker
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>