COOLON CP12UG Industrial LED Luminaire Instruction Manual
- June 12, 2024
- COOLON
Table of Contents
CP12UG INDUSTRIAL LED MANUAL
EDITION 1.0
CP12UG Industrial LED Luminaire
CP12UG Luminaire with Standard Bracket Optional Clip-
on Cover
ACC-CP12-COVER (available separately)
Technical Specifications
Voltage In | Power | IP/IK Rating |
---|---|---|
7 – 15VDC | 50W @ 12VDC | IP66 / IK09 |
INSTALLATION INSTRUCTIONS
Adjust the mounting angle and secure the CP12UG lamp to the mounting bracket using the Norlock Washers and M10 hex screws.
WIRING
Visit the following link or scan the QR code for a quick demonstration showing the removal and installation of the clip-on cover: goo.gl/OZvYjc
ATTENTION:
Unit must not be operated with the clip-on cover and optical face blocked or
obstructed.
The clip-on cover and other optical surfaces are to be kept clean for optimal
light output and to prevent damage to the integral optics and cover.
Replace the clip-on cover if it is damaged or cannot be cleaned. Damage to the
fitting due to operation with an obstructed optical face will not be covered
by warranty.
www.coolon.com.au
support@coolon.com.au
• aus. 1300 287 533
• intl. +613 8681 3633
• www.coolon.com.au
Product must be installed by a suitably qualified person.
All documentation is subject to change without notice.
Refer to our website for the latest information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>