KS VERLICHTING 7375 Stable Lamp Wall Lamp Dolce Retro Instruction Manual
- June 12, 2024
- KS VERLICHTING
Table of Contents
KS VERLICHTING 7375 Stable Lamp Wall Lamp Dolce Retro
Product Information
The Dolce 7375 | 7376 | 7377 | 7378 | 7379 | 7385 | wandlamp is a wall-mounted lamp manufactured by KS Verlichting. It is available in various models with different product codes.
Please note that the drawings provided in the user manual are for illustrative purposes only, and the actual model of the lamp may vary.
For more information, please visit the official website of KS Verlichting: www.ks-verlichting.nl
Date of Manual: May 2020
Product Usage Instructions **
**
(GB)
Follow the below instructions for the assembly and installation of the Dolce wall lamp:
- Check if all the necessary parts are included.
- Ensure that the power supply to the installation area is turned off.
- Place the wall mounting plate at the desired location and mark the mounting points.
- Drill holes at the marked points and securely attach the wall mounting plate to the wall.
- Connect the electrical wiring according to the applicable safety standards and place the lamp on the wall mounting plate.
- Turn on the power supply again and test the operation of the wall lamp.
INSTALLATION
HOW TO USE
Assembly and installation instructions
- The light fitting must be installed by a qualified electrician. The main supply must be disconnected at the fuse box before starting installation. Before starting with installation, use a voltage tester to make sure the wiring is off circuit. You also need to ensure that in relation to the earthing on the electrical lead the local regulations are observed.
- Drill holes in the wall. Then insert the plugs. Put the cable from the wall through the Hole in the back plate.
- Attach the wires. Prevent humidity on all components. Make sure there is a watertight seal. Keep the correct colors in track: Blue lead = Neutral (N) Brown – Black lead = Live (L) Yellow/ Green lead = Earth ( ). The earth wire (yellow / green) is to be connected to the earth screw / wire of the armature. You can screw the lamp holder on the back plate.
- Make sure you put a light bulb corresponding to the type and wattage as indicated on the packaging. Then you can place the lamp over the screws in the wall.
- Please use gloves before placing the glass, because of possible sharp edges. Place the glasses in the lamp.
- Switch on the main supply. The light is now ready for use.
Maintenance requirements
It is recommended that the surface is rubbed regularly with a neutral oil or water without cleaning agents and then wiped with a soft cloth. Keep the armature free from a salty environment, coastal location and an acid free environment, this affects the armature. Rub it regularly with Carwash, it ensures a longer lifetime of the armature. In case of damage or fracture of the protective glass, replace the glass directly to insure the IP value. Make sure when replacing the lamp that the power is off and the lamp has cooled down.
The drawings are for illustrative purposes only. They may vary in model of the lamp.
Mei 2020
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>