KS VERLICHTING 5127 Ancona Standing Wall Light Instruction Manual
- June 12, 2024
- KS VERLICHTING
Table of Contents
KS VERLICHTING 5127 Ancona Standing Wall Light Instruction Manual
Assembly and installation instructions
- The light fitting must be installed by a qualified electrician. The main supply must be disconnected at the fuse box before starting installation. Before starting with installation, use a voltage tester to make sure the wiring is off circuit. It is not sufficient just to turn off the power at the switch. You also need to ensure that in relation to the earthing on the electrical lead the local regulations are observed.
- Drill holes in the wall.
- Then insert the plugs.
- Put the cable from the wall through the Hole in the installation base. Screw the installation base on the wall.
- Then led the wires to the luster terminal. Connect the wires from the wall to the connector block. Prevent humidity on all components. Make sure there is a watertight seal. Attach the wires, and keep the correct colors in track: Blue lead = Neutral (N) Brown or Black lead = Live (L) Yellow/Green lead = Earth (not on class II light fittings) Note that: the (brown) wire L1 corresponds to the mains cable L (or the connector marked with the symbol L), the (blue) wire N1 corresponds to the neutral conductor N (or the connector marked with the symbol N), the (yellow / green) wire 1 corresponds to the earth cable (or the luster terminal with symbol )
- +7. You can place the lamp over the mounting plate.
- Please use gloves before placing the glass, because of possible sharp edges. Attach the glass in the lamp.
- Now place the threaded pins in the frame.
- Make sure you put a light bulb corresponding to the type and wattage as indicated on the packaging.
- Screw the tip of the lid.
- Now attach the lid with the cap nuts on the frame.
- Switch on the main supply. The light is now ready for use.
Maintenance requirements: It is recommended that the surface is rubbed regularly with a neutral oil or water without cleaning agents and then wiped with a soft cloth. Keep the armature free from a salty environment, coastal location and an acid free environment, this affects the armature. Rub it regularly with Carwash, it ensures a longer lifetime of the armature. In case of damage or fracture of the protective glass, replace the glass directly to insure the IP value. Make sure when replacing the lamp that the power is off and the lamp has cooled down.
The drawings are for illustrative purposes only.
They may vary in model of the lamp.
Costumer Support
www.ks-verlichting.nl
Update: Mei 2017
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>