DPR BED01 Easy Dispenser User Manual

June 4, 2024
DPR

DPR BED01 Easy Dispenser User Manual

BOX OPENING AND PULL OUT THE DEVICE

Hold the box and slip the dispenser off.

PROCEDURE TO ALIGN THE ROLL SUPPORT

Please unscrew the rear support for the roll through the screwdriver and screw it to the 3 holes present on the base

PROCEDURE TO LOAD THE ROLL

Please insert the roll into the roll core holder and block the roll in through the apposite roll blocking holder pressing it against the roll until the springs start working.
NOTE : if during the working operations, the device dispenses more than one label or has difficulty unrolling, please move the holder increasing or decreasing its pressure.

PROCEDURE TO DISPENSE

Please open the dragging roller and let the backing paper slide between the 2 rollers.

Close the dragging roller. Push the black button to help the advancing of the backing paper up to the reaching of the backing paper rewinding holder.

Please fasten the backing paper to the backing paper rewinding holder using the fork.

The knob allows to set up the length of the label to be dispensed

PROCEDURE OF OPERATION

By pushing the black button “yellow led on”, the advancing is manual.
By pushing the green button “green led on”, the advancing is automatic.
By pushing again the green button “yellow led on”, the advancing is automatic again. Please spin the knob to set up the length of the label to be dispensed.
The sensor is already adjusted by our technicians. Use this procedure if you have special labels that are not read by the sensor.
The sensor is already adjusted by our technicians. Use this procedure if you have special labels that are not read by the sensor.

Label rewinder, label unwinder, electronic label dispenser and more..

FOR MORE INFO CONTACT YOUR RESELLER

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals