dpr LABELING VP485 VIPColor Unwinder User Manual

dpr LABELING VP485 VIPColor Unwinder

APPLICATIONS

The VIPColor VP485 Unwinder is used to unwind labels onto a 3” core holder. The unwinder can handle labels up to 220mm (8.6”) wide and unwind rolls with external diameter up to 250mm (10”).

POWER SUPPLY

An external power supply 100/240VAC – 2.5A at 24V allows an electronic circuit to provide, through the tension arm, the speed and sense of rotation auto adjustment.

FUNCTIONING

The printer must be put onto the unwinder’s printer plate, in this way the correct unwinding operations are guaranteed and also the device is fastened to the printer.
The unwinder has two types of speed adjustments, through the two buttons it is possible to set the maximum speed required while the tension arm will auto adjust the speed from zero to the set value and the sense of rotation.

WORKING CONDITIONS

• When the printer forwards the media for printing, the tension arm goes up, the device unwinds the media. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
• When the tension arm is in the middle position, the device is idle. Both yellow and green leds on.
• When the printer backwards the media, the tension arm goes down, the device rewinds it.

Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
When the unit is operating but the media is not loaded or it runs out, the tension arm reaches the lowest position and after few seconds the unit will stop by itself, both leds blink and it beeps.

CONTROL PANEL

• ON-OFF
  Push this button to turn On or Off the unit.

• INCREASE SPEED
  Push this button to increase the rotation speed.

• DECREASE SPEED
  Push this button to decrease the rotation speed.

• LABEL FACE-OUT
  Turn the unit off. Keep pushed “FACE OUT” button, push and release “ON-OFF” button while the green led turns on and off. The unit is now ready to operate.

• LABEL FACE-IN
  Turn the unit off. Keep pushed “FACE IN” button, push and release “ON-OFF” button while the yellow led turns on and off. The unit is now ready to operate.

INSTALLATION

1. STEP 1
   Remove the two knobs from the unwinder’s plate.

2. STEP 2
   Put the second plate near the first one.

3. STEP 3
   Use the two knobs to fasten the plates.

4. STEP 4
   Install the support and load the roll onto the core holder.

5. STEP 5
   Insert the outer disc onto the core and screw the knob.

6. STEP 6
   Install the support and fasten it to the base through the knob.

SMART SOLUTIONS FOR THE LABELING INDUSTRY

Label rewinder, label unwinder, electronic label dispenser and more…

– FOR MORE INFO CONTACT YOUR RESELLER –

Please keep the original packaging in case you need to return the unit. If we receive the system in non-original packaging, the warranty may be void.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>