dpr LABELING LX1000 Primera Label Printers User Manual
- June 4, 2024
- dpr LABELING
Table of Contents
dpr LABELING LX1000 Primera Label Printers
Please keep the original packaging in case you need to return the unit. If we receive the system in non-original packaging, the warranty may be void.
APPLICATION
The rewinder is used to unwind the labels on roll having fixed 3” internal diameter. The maximum external roll diameter allowed is up to 250 mm (10”) while the maximum label width is up to 220 mm (8.66”).
POWER SUPPLY
An external power supply 100/240VAC – 2.5A at 24V allows an electronic circuit
to provide, through the tension arm, the speed and sense of rotation auto
adjustment.
FUNCTIONING
The printer must be put onto the unwinder’s printer plate, in this way the
correct unwinding operations are guaranteed and also the device is fastened to
the printer.
The unwinder has two types of speed adjustments, through the two buttons it is
possible to set the maximum speed required while the tension arm will auto
adjust the speed from zero to the set value and the sense of rotation.
WORKING CONDITIONS
- When the printer forwards the media for printing, the tension arm goes up, the device unwinds the media. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
- When the tension arm is in the middle position, the device is idle. Both yellow and green leds on.
- When the printer backwards the media, the tension arm goes down, the device rewinds it. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
When the unit is operating but the media is not loaded or it runs out, the tension arm reaches the lowest position and after few seconds the unit will stop by itself, both leds blink and it beeps.
CONTROL PANEL
-
ON-OFF
Push this button to turn On or Off the unit. -
INCREASE SPEED
Push this button to increase the rotation speed. -
DECREASE SPEED
Push this button to decrease the rotation speed. -
LABEL FACE-OUT
Turn the unit off. Keep pushed “FACE OUT” button, push and release “ON-OFF” button while the green led turns on and off. The unit is now ready to operate. -
LABEL FACE-IN
Turn the unit off. Keep pushed “FACE IN” button, push and release “ON-OFF” button while the yellow led turns on and off. The unit is now ready to operate.
INSTALLATION
- STEP 1 Unsrew the two knobs from the unwinder’s plate.
- STEP 2 Set the included printer plate beside the unwinder’s plate.
- STEP 3 Use the two knobs to fasten the printer plate to the unwinder’s plate.
- STEP 4 Load the roll onto the core holder.
- STEP 5 Insert the outer disc onto the core and screw the knob.
- STEP 6 Install the support and fasten it to the base through the knob.