dpr LABELING CSR111 Small Reel to Reel User Manual
- June 4, 2024
- dpr LABELING
Table of Contents
dpr LABELING CSR111 Small Reel to Reel User Manual
MONTAGGIO
BOBINA
STEP 1
Load the roll on the core holder to the left of the unwinder.
STEP 2
Adjust the core holder and fix it with the knob to the rear disc.
STEP 3
Load the cardboard core on the core holder of the rewinder.
STEP 4
Adjust the core holder and fix it with the knob to the rear disc.
STEP 5
Stick the roll of labels to the cardboard core.
STEP 6
Install the outer disc. The unit is ready to be used.
IMPORTANT:
Switch off the unit before loading the media.
WORKING CONDITIONS
- When the tension arm goes up, the unwinder increases the rotation speed.
- When the tension arm goes down, the unwinder decreases the rotation speed.
- When the tension arm reaches the lowest position and after a few seconds the rewinder’s rotation will be stopped while both LEDs blink and it beeps.
CONTROL PANEL
ON-OFF
Push this button to turn On or Off the unit.
INCREASE SPEED
Push this button to increase the rotation speed.
DECREASE SPEED
Push this button to decrease the rotation speed.
LABEL FACE-OUT
Turn the unit off. Keep pushing the “FACE OUT” button, and push and release
the “ON-OFF” button while the green lead turns on and off. The unit is now
ready to operate.
LABEL FACE-IN
Turn the unit off. Keep pushing the “FACE IN” button, and push and release the
“ON-OFF” button while the yellow lead turns on and off. The unit is now ready
to operate.
SMART SOLUTIONS FOR THE LABELING INDUSTRY
Label rewinder, label unwinder, electronic label dispenser, and
more…
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>