VISUAL COMFORT 4155701 Codyn Wall Light Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
**VISUAL COMFORT 4155701 Codyn Wall Light Instruction Manual
**
GENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent version may be dimmed with a standard incandescent dimmer.
LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation
CAUTION RISK OF FIRE –
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave., Skokie, IL 60077
T: 847.410.4400 | F: 847.410.4500
Website: www.visualcomfort.com
©2023 Visual Comfort & Co.. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification
Install the Fixture
- Secure the mounting plate to the junction box.
- Place the shade on to the socket and secure it in place by screwing the shade collar nut onto the socket. Do not over tighten. If necessary, repeat for all the other shades.
- Screw the lamp(s) into the socket(s). Refer to the label on the socket for Max Wattage Information.
- Connect the fixture to a suitable ground in accordance with local electrical codes.
- Connect the white fixture wire to the neutral power line wire with a wire nut.
- Connect the black fixture wire to the hot power line wire with a wire nut.
- Neatly place the wires into the junction box, place the fixture onto the mounting studs, and secure it in place by screwing the cap nuts onto the studs.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>