ET2 E25087-142BK Burst 9-Light LED Pendant Instruction Manual
- June 12, 2024
- ET2
Table of Contents
ET2 E25087-142BK Burst 9-Light LED Pendant
Item/Model Number: E25087-142BK
Please consult a qualified electrician prior to install
Before Getting Started
- Read the instructions carefully prior to assembling the product.
- When you open the package with a sharp tool like a box knife, be careful not to damage the components inside.
- Carefully remove all packaging materials and retain for future use.
- Keep all hardware parts and packaging out of reach or small children.
- Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
- Ensure that you have all required contents for complete assembly.
- Take care when lifting. Assemble the product in close proximity to where you intend to install it.
- Do not over tighten the screws and bolts as this may damage the threads.
- Do not let children play with this product.
- Risk of suffocation!
- Keep packaging materials away from children.
Lamp Care Instructions
- Carefully read through the instruction sheet before assembly and using the product. Caution there is a risk of shock!
- Disconnect from power source before assembling or cleaning.
- Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
- Only use the recommended bulb type and do not exceed the maximum wattage as it could cause fire.
- Check the product cord to be sure is free torn or frayed.
WARNING: Wires must to be connected to low voltage driver and should not be connected directly to live wire or a short may occur.
Cleaning & Maintenance
- On polished finishes, often using talc powder can reduce the appearance of fingerprints and other smudges.
- For respective shade surfaces, use the appropriate cleansers, i.e. glass cleaner, stone polish, & wood polish.
- Clean with soft cloth and a mild detergent. Do not use abrasive or harsh cleaners.
- Periodically (every 90-180 days) make sure that the screws are fully tightened.
- Prolonged exposureto heat sources may cause glazing, melting and scorching, or even cause color to fade.
PARTS
Before getting,started,ensure the package contains the following
components:
Install For Pendant
- Run wire through stems and combine stem lengths to meet desired mounting height.
Install For Semi Flush Mount
MUST be installed by an experienced professional CRITICAL KNOWLEDGE of electronic lighting systems required
ITEM/MODEL: E25087-142BK
IMPROPER WIRING and/or INCORRECT DIMMER use can cause CATASTROPHIC DAMAGE! THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH DO NOT CUT FACTORY-MADE CONNECTIONS.
VOLTAGE INPUT
IMPORTANT!
If the control is not paired properly to LED fixtures, irreparable damage
may occur. If the dimmer you are using is not listed here, consult a lighting
professional or view our Dimming Compatibility Chart online:
www.et2online.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>