DPR Label Rewinder All-In-One Series Label Printers User Manual
- June 4, 2024
- DPR
Table of Contents
DPR Label Rewinder All-In-One Series Label Printers
Please keep the original packaging in case you need to return the unit. If we receive the system in non-original packaging, the warranty may be void.
APPLICATIONS
Those units are used to rewind/unwind the labels coming from the input or output of color label printers onto an adjustable core holder from 40mm (1.57”) up to 118mm (4.64”) or onto the 76mm (3”) fixed core holder. The maximum label roll diameter can be 250mm (9.84”) or 300mm (11.81”) and the maximum label width can be 244mm (9.60”) depending on the selected model.
POWER SUPPLY
An external power supply 100/240VAC – 2.5A at 24V allows an electronic circuit to provide, through the tension arm, the speed and sense of rotation auto adjustment.
INSTALLATION
STEP 1
Unscrew the two knobs.
STEP 2
Set the included printer plate beside the unit’s base.
STEP 3
Screw both plates with the two knobs.
HOW TO OPEN THE CORE HOLDER
Adjustable core holder
3” Fixed core holder
WORKING CONDITIONS
LABEL REWINDER “all-in-one” series:
- When the printer forwards the media for printing, the tension arm goes down, the device rewinds the media. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
- When the tension arm is in the middle position, the device is idle. Both yellow and green LEDs on.
- When the printer backward the media, the tension arm goes up, and the device unwinds it. Yellow or green led depending on the selected rewinding mode (face-in or face-out).
LABEL UNWINDER “all-in-one” series:
- When the printer forwards the media for printing, the tension arm goes up, the device unwinds the media. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
- When the tension arm is in the middle position, the device is idle. Both yellow and green leds on.
- When the printer backward the media, the tension arm goes down, the device rewinds it. Yellow or green led on depending on the selected rewinding mode (face-in or face-out).
When the unit is operating but the media is not loaded or it runs out, the tension arm reaches the lowest position and after few seconds the unit will stop by itself, both leds blink and it beeps.
CONTROL PANEL
ON-OFF
Push this button to turn On or Off the unit.
INCREASE SPEED
Push this button to increase the rotation speed.
DECREASE SPEED
Push this button to decrease the rotation speed.
LABEL FACE-OUT
Turn the unit off. Keep pushing the “FACE OUT” button, and push and release
the “ON-OFF” button while the green led turns on and off. The unit is now
ready to operate.
LABEL FACE-IN
Turn the unit off. Keep pushing the “FACE IN” button, and push and release the
“ON-OFF” button while the yellow led turns on and off. The unit is now ready
to operate.
SMART SOLUTIONS FOR THE LABELING INDUSTRY
Label rewinder, label unwinder, electronic label dispenser, and more
Other Product
FOR MORE INFO CONTACT YOUR RESELLER.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>