luminii PS010VD-3X96-24-WW 0-10V Power Supply Instruction Manual
- June 13, 2024
- luminii
Table of Contents
luminii PS010VD-3X96-24-WW 0-10V Power Supply
Product Information
- Product Name: 0-10V Power Supply 3 x 96 Watt
- Model: PS010VD-3X96-24-WW
Dimensions :
- Height: 13.00 inches
- Width: 6.60 inches
- Depth: 4.20 inches
- Maximum Load: 3 x 96 Watts
Product Usage Instructions
- Before installation, check the label on the power supply to ensure it has the proper input voltage, output voltage, and wattage for the job.
- Remove the wiring compartment cover and knockouts on both ends of the power supply.
- Connect the white (neutral) and black (hot) power supply wires to the corresponding power wires (120-277 VAC). Connect the ground wires according to local electrical codes.
- Refer to the wiring diagrams on page 2. Feed the wire into the terminal block hole by inserting a small flat-head screwdriver into the terminal block slot and pushing down. Insert the wire lead and release the screwdriver to secure the wire in place.
- Secure the compartment cover back onto the power supply.
Please read all instructions prior to installation and keep for future
reference!
This class 2 power supply is to be installed by a qualified electrician in
accordance with the National Electrical Code (NEC) and local building codes.
The power supply must be installed in a well ventilated area and free from
explosive gases and vapors. Proper operation requires the free flow of air.
Power supply is well suited for LED or resistive loads at or below their
maximum output rating per circuit. Suitable For Damp Location.
WARNING! Risk of Fire or Electric Shock, Do Not Interconnect Output Terminal.
- Before installing, check the label and ensure the power supply has the proper input voltage, output voltage, and wattage for the job. Check the wire markings to ensure they match the wiring diagram below. Refer to table above for the maximum loads supported by each power supply
- Remove the wiring compartment cover and knockouts on both ends of the power supply to connect.
- Connect the white (neutral) and black (hot) power supply wires to the white and black power wires ( 120 – 277 VAC ). Followed by connecting the ground wires in accordance with local electrical codes.
- Reference wiring diagrams on page 2. Feed wire into the terminal block hole by intserting a small flat-head screwdriver into the terminal block slot and push down, thus opening the terminal block hole. Then, insert the wire lead and release the screwdriver to secre wire in place.
- 1 Secure compartment cover back onto the power supply
WIRING DIAGRAM
LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>